695358
31
Zoom out
Zoom in
Previous page
1/64
Next page
English
USER MANUAL
Table 1: Diagnosis of malfunctions
Problem
A. Smoky air / smoke
blowback
B. Soot deposits on glass
pane
C. Soot deposits on the
inside of the fireplace
D. Dark smoke
E. Discolouration on
outside of fire
F. Tears in the inner lining
G. Corrosion on the fire
H. handle or hinge is
running stiffly
Remedy
1. Open a skylight or slightly open a window to
supply fresh air; if possible, switch off the
cooker hood.
2. Have the flue duct inspected/cleaned
1. Use properly dried wood (3.1)
2. Allow the fire to burn through better:
2.1 use smaller kindlings
2.2 leave the air supply slide fully open for
longer
2.3 leave at least 2 cm of ash (3.4)
3. See Tabel 2 for using the recommended
amount of wood.
1. Allow the fire to burn through better by
temporarily opening the primary air supply.
1. Use properly dried wood (3.1)
2.1 have the duct inspected.
2.2 allow the fire to burn through better by
opening the primary air supply.
3. open a skylight or slightly open a window to
supply fresh air; if possible, switch off the
cooker hood.
1. See Tabel 2 for using the recommended
amount of wood.
1. Leave at least 2 cm of ash (3.4)
2. See Table 2 for using the recommended
amount of wood
3. Fill with sufficient care
1. Check chimney
2. Lightly sand and spray (see section 6.2)
1. Grease rotating parts with teflon dry-film
lubrication.
Possible cause
1. Smoke / smoky air coming from
the fire due to underpressure in
the room where it is installed
2. Poorly functioning flue duct
1. Moist wood.
2. Burning with too low efficiency,
because:
2.1 kindlings are too big;
2.2 primary air supply is closed too
quickly
2.3 there is too little ash on the fire
bottom
3. load is too large
1. Incomplete combustion
1. Moist wood.
2. Poorly draughting flue duct
3. Too little air supply
1. Overload by exceeding max.
amount of wood
1. No ash on fire bottom
2. Overload fire
3. Inaccurate filling
1. Leakage/condensation chimney
2. Wet cloth used during
maintenance
1. Too little lubrication
UK
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dik Geurts Lars 900 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dik Geurts Lars 900 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info