716642
19
Zoom out
Zoom in
Previous page
1/41
Next page
www.dickinsonmarine.com ~ info@dickinsonmarine.com
Form#7.2-229 Issue#2
19
9. Optional Hot Water Coil Installation
A hot water coil can be added to also enjoy water heating from your
Dickinson diesel heater. You can either order your heater with one already
installed in the heater or you can install the coil later yourself. Hot water
coils are made of 5/8” OD stainless steel tubing and are available in a 1 turn
coil for all model heaters to heat approx. 5-10 gallons of water. Hot water
coils are also available in 2 turn coils for only the Antarctic and Lofoten
models to heat approx. 15-20 gallons of water. To plumb the hot water to the
heater, ½” copper tubing should be used with the compression fittings
provided.
The coil in a heater can be used to heat the water in your existing hot water
supply tank. If the tank is mounted above the lower coil, the water will
circulate on its own from the tank into the hot coils and rise back into the
tank by convection. If not, the water will need to be circulated by a low
volume water pump. The temperature of the water will change depending on
the speed of which it’s circulating and the operating settings on the heater.
It takes approx. 3000 btu’s to raise 10 gallons of water to 30 degrees in 1
hour. Most of the btu’s that the heater produces is dissipated as radiant heat
and is expelled through the chimney. Therefore, only a general guideline as
to water heater capability can be set.
WARNING: A pressure relief valve must be present or dangerous pressure
buildup will occur.
* See typical coil install diagrams on pg. 20*
It is best to order the heater with the coil already installed but follow these
instructions for replacing or installing a new coil.
1. Remove the nuts holding the outer shield and open the front door to
manipulate the front and back shield off the Newport and Alaska model
heaters.
2. Remove the top baffle from inside the firebox.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dickinson Marine Newport at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dickinson Marine Newport in the language / languages: English as an attachment in your email.

The manual is 2,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info