739157

Dibea DU100 Manual

3
Zoom out
Zoom in
Previous page
1/4
Next page
UNPACKING AND SET-UP
CASTER ASSEMBLY
PICK-UP OPERATION
DRY PICK-UP OPERATION–INSTALLING THE DISPOSABLE FILTER BAG
WET PICK-UP OPERATION
EMPTYING LIQUID WATERS FROM THE TANK
15, Squeegee 16, Utility Nozzle
1. Remove the power-head by pulling latches in an outward motion, and some accessories that may have been shipped in the tank
With the power head in an upside down position, slide the cartridge lter down over the
lid cage, push the lter seals against the power head.
Place lter retainer into the top of the cartridge lter, hold the powe head with one hand,
turn the handle on the lter retianer clockwise to tighten, locking the lter into place.
To remove the lter for cleaning, again hold the power head and turn the lter retainer
counter-clockwise to loosen and remove, slide the cartridge lter off the lid cage.
To clean the cartridge lter shake or brush off excess dirt or rinse (from the inside of the
lter) with water, dry completely (approximately 24 hours) and re-install.
1. Using for dry pick-up only.
2. Unscrew locking-ring and remove hose.
3. Slide collar of lter bag into retainer guides.
4. Reinsert hose.
5. When secured in place, expand bag and position around the inside of
the tank.
This cleaner requires only a minimum of conversion when going from dry to wet pick-up. Remove ALL dry pick-up lters. After completing a wet
pick-up job, raise the hose to drain any excess liquid into the tank before shutting off. The interior of the tank should be periodically cleaned.
1. Always disconnect the plug from the wall receptacle before removing the power head. Place power head in an upside down position. Remove
foam lter by sliding it up and off the lid cage.
2. Shake excess dust off foam lter with a rapid up and down movement.
3. Hold foam filter under running water for a minute or two, rinsing from the inside. A water wash is not always required, depending on the
condition of the foam lter.
4. Gently wring out excess water, blot foam lter with a clean towel, and allow to dry. The foam lter is now ready to install.
NOTE: WET PICK-UP ACCESSORIES SHOULD BE WASHED PERIODICALLY, ESPECIALLY AFTER PICKING UP WET, STICKY KITCHEN
ACCIDENTS. THIS CAN BE ACCOMPLISHED WITH A WARM SOLUTION OF SOAP AND WATER.
Your Wet/Dry may be emptied of liquid waste by removing the power head. To empty, stop the motor and remove the plug from the wall
receptacle. Remove the power head and deposit the liquid waste contents in a suitable drain. After the tank is empty, return the cover to its
original position. To continue use, plug the cord into the wall receptacle and start the motor.
2. Attach casters following the instruction and illustration in this manual.
3. Before replacing power-head, please refer to Dry Pick-up or Wet Pick-up Operation in this manual to ensure you have the proper filters
installed for your cleaning operation.
4. Replace power head on the tank by aligning tabs with lugs by applying pressure at the middle point of the clip.
5. Insert exible hose end into inlet of tank and tighten.
6. Attach the extension wands to the accessory end of the hose. Twist slightly to tighten the connection
1. Turn tank upside down so that bottom is facing up.
2. Install casters into dolly by inserting the caster stems into the holes
provided. Apply pressure and twisting motion until casters snap into place.
Caster will swivel easily when positioning is correct.
3. Return tank assembly upright position
7. Attach one of the cleaning accessories (depending on your cleaning requirements) on the extension wands. Twist slightly to tighten the
connection.
8. Plug the cord into the wall outlet. Your cleaner is ready for use.
WARNING-
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET BEFORE REMOVING THE POWER-HEAD.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dibea DU100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dibea DU100 in the language / languages: English as an attachment in your email.

The manual is 0,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info