648038
27
Zoom out
Zoom in
Previous page
1/32
Next page
5.6 Brakes adjustment
5.6.1 Bicycles equipped with derailleur
As soon as brakes begin to lose efficiency, it is necessary
to recover the wear of the brake shoes.
Adjustment can be effected on the backing plate of the
brake drums (see fig. 22 and fig. 23):
* Unlock the lock nut (C);
* To tighten the brake: unscrew the hollow bolt (A)
until the cable becomes tight while the wheel still
turns freely.
* Lock the lock nut (C) by tightening it clockwise, making
sure that the hollow bolt (A) does not turn with it.
* Spin the wheel and test brake efficiency.
Readjust if necessary. Try to obtain the maximum
braking efficiency before that the brake lever
touches the handlebar.
For brake maintenance, see Sec 6.2
5.6.2 Bicycles equipped with three speed hub
For the rear brake: see separate manual.
5.6 Einstellung der Bremsen
Sobald die Bremsen anfangen, an Wirksamkeit zu
verlieren, müssen sie gewartet werden. Einstellungen
nnen an der Platte der Bremse vorgenommen werden
(siehe Abb. 22 und Abb. 23):
* Lösen Sie die Kontermutter (C)
* Um die Bremswirkung zu erhöhen, lösen Sie die
Schraube (A)
* Ziehen Sie wieder die Mutter an (C). Achten Sie
darauf, dass die Schraube nicht mitdreht.
* Drehen Sie das Rad und prüfen Sie, ob es frei
dreht.
* Stellen Sie - wenn nötig - nach.
Stellen Sie sicher, daß Sie die maximale
Bremswirkung erreichen; die optimale
Bremswirkung wird nur dann erzielt, wenn der
Bremshebel den Lenker nicht mehr berührt, obwohl
er vollständig gezogen ist.
Wartung, siehe Kap. 6.2.
5.6 Afstellen van de remmen
Zodra de remmen slechter beginnen te remmen, is het
nodig de remschoenen te vernieuwen.
De afstelling vindt plaats bij de remmen (zie fig. 22
en 23):
* Draai de borgmoer (C) los;
* Om de rem strakker te maken draait u de holle
bout (A) zo ver los dat de remkabel strak staat
terwijl het wiel nog vrij kan draaien;
* Zet de borgmoer (C) vast door deze rechtsom te
draaien. Let op dat de holle bout (A) niet meedraait;
* Draai het wiel rond en controleer de werking van de rem.
* Stel de rem zo nodig bij. De rem moet de volle
remkracht bereiken vlak voordat de remhendel
tegen het stuur komt. Zie onder 6.2. voor
onderhoud van de remmen.
5.6.2 Voor vouwfietsen uitgerust met een 3-
versnellingen naaf; zie bijgeleverde losse handleiding.
Voor de achterrem; zie de losse handleiding.
GB D NL
Fig. 22
Fig. 23
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Di Blasi R5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Di Blasi R5 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info