652179

DeWalt DCM563 Manual

39
Zoom out
Zoom in
Previous page
1/164
Next page
37
english
SIDE TRIMMING HEDGES (FIG. 10)
Orient the trimmer as shown and begin at the bottom
and sweep up.
DANGER: KEEP HANDS AWAY FROM
BLADES.
WARNING: To guard against injury,
observe the following:
• READ INSTRUCTION MANUAL
BEFORE USING. SAVE INSTRUCTION
MANUAL.
• Check the hedge for foreign objects
such as wires or fences before each
use.
• KEEP HANDS ON HANDLES. DON’T
OVERREACH.
• DO NOT USE UNDER WET
CONDITIONS.
CAUTION: BLADE MAY COAST AFTER
TURN OFF
MAINTENANCE
Your DeWALT power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up can
cause injury.
The charger and battery pack are not serviceable.
Lubrication (Fig.11)
1. After use, carefully clean the blades with a
resin solvent.
2. After cleaning, apply a light film of lubrication to
the exposed blade.
3. Turn the trimmer vertical with the blades toward
the ground and run the trimmer for a few
seconds to fully disperse the lubrication.
4. Slide the sheath (G) over the blade until it snaps
into place as shown in Figure 11.
Proper Hand Position (Fig. 6)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the
switch handle (C), with the other hand on the bail
handle (E).
Switching On (fig. 7)
1. Squeeze and hold the bail handle (E) with one
hand so that the front part of the bail handle is
pulled back into the body of the bail handle.
2. Push the lock off switch (B) forward and
squeeze the trigger switch (A). Once the unit is
running, you may release the lock off switch.
In order to keep the unit running you must continue
to squeeze the trigger. To turn the unit off, release
the trigger.
WARNING: Never attempt to lock a
switch in the ON position.
WARNING: Do not cut stems
greater than 3/4 inch (19mm). Use
the trimmer only for cutting normal
shrubbery around houses and
buildings.
Trimming Instructions
WORKING POSITION (FIG. 6)
Maintain proper footing and balance and do not
overreach. Wear safety goggles, non-skid footwear
when trimming. Hold the unit firmly in both hands
and turn the unit on. Always hold the trimmer as
shown in Figure 6, with one hand on the switch
handle (C) and one hand on the bail handle (E).
Never hold the unit by the blade guard (D).
TRIMMING NEW GROWTH (FIG. 8)
Using a wide, sweeping motion, feeding the blade
teeth through the twigs, is most effective. A slight
downward tilt of the blade in the direction of
motion gives the best cutting.
LEVEL HEDGES (FIG. 9)
To obtain exceptionally level hedges a piece of string
can be stretched along the length of the hedge as
a guide.
… 39 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeWalt DCM563 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeWalt DCM563 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Portuguese, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 26,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info