14 Installation
devolo dLAN pro 1200 DINrail
DANGER! Shock hazard
Components powered by the mains supply
have to be secured with a circuit breaker.
An easily accessible disconnecter (such as a
circuit breaker) must be available for each
connected external conductor.
쎲 The device is intended for installation on the top-
hat rail in the installation area of overvoltage
category 3 or lower.
쎲 Never open the device. There are no user-service-
able parts inside the device.
쎲 Use the device in a dry location only.
쎲 Do not insert any objects into the openings of the
device.
쎲 Slots and openings on the case serve as ventila-
tion. Never block or cover them.
쎲 Do not keep the device in direct sunlight.
쎲 Never set up the device near a heater or radiator.
쎲 The device should be located only where sufficient
ventilation can be ensured.
쎲 Never use the device with a power supply that
does not meet the specifications provided on the
rating plate.
쎲 In the event of damage, contact customer service.
This applies, for example, if
쑗 liquid has been spilled on the device or
objects have fallen into the device.
쑗 the device has been exposed to rain or water.
쑗 the device does not work, even though the
operating instructions have been followed
properly.
쑗 the device’s case is damaged.
3.2 Electrical installation
햲 Install the dLAN pro 1200 DINrail properly on the
top-hat rail.
Take into account the vertical installation align-
ment of the device, so that the mains power
supply comes from above.
햳 Now connect the conductors according to the line
connections.
When connecting to the sockets, make sure the
conductor cross-section is 0.18 mm² to 6 mm².