Manual Denver WCT-5003MK2 (page 6 of 15) (English)

657774

Zoom out

Zoom in

1/15

ENG-6

3. Easy Operation

3.1 Power Supply

To supply power for the camera, four or eight AA size batteries are needed.

Open the bottom cover. Confirm that the power switch is at the OFF (Right) position, pull

out the battery depot. Load the fully charged batteries into the depot according the

polarities sign shown below. Push back the battery compartment to the battery

chamber.

The following batteries with 1.5V output can be used:

1. High-density and high-performance alkaline batteries (Recommended)

2. Rechargeable NiMH batteries

There are four battery slots. Slot 1 and 2 form one group (“1” will mark on depot), while

slot 3 and 4 form the other group (“2” will mark on depot) where each group can supply

the power individually.

When in Test Mode, camera will be automatically shut down to save power if without

any operation within 3 minutes; it could be waked up by any movement detection.

When in low-battery state, camera will be also automatically shut down. Please change

the batteries in time.

3.2 Insert the SD-card

Insert SD-card into the card slot with marked side upwards.

Please note that the SD-card can only be plugged in one direction. Make sure that the

write-protect switch of the SD-card is on the “write” position.

3.3 Power on and Enter into the ON Mode

Before switching on, please pay attention to the following:

1. Avoid temperature and motion disturbances that could be construed as animals

or humans such as trees that are exposed to direct sunlight for much of the day

or any other heat source. These may cause false triggers.

2. The height from ground for placing the camera should 1 meter with the object.

For example for deer waste height is good size appropriately. In general, one to

two meters are preferred.

Slide the power switch to the ON position to power on the camera and enter into the ON

mode.

After switching on the camera, the motion indication LED (red) will blink for about 15s.

The 15s is a buffering time before automatic capturing photos or videos, e.g. for closing

and locking the bottom cover, fixing the camera on a tree and walk away.

In ON mode, the camera will take pictures or videos automatically according to the

default settings or previous custom settings. The camera has the sound recording

function, so the sound will be embedded in the video clip while capturing a video.

How can the password be reset if I have forgotten the code. Submitted on 9-7-2021 at 23:17
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Denver WCT-5003MK2 in the language / languages: English as an attachment in your email.

The manual is 0,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Denver WCT-5003MK2

Denver WCT-5003MK2 Quick start guide - English - 2 pages

Denver WCT-5003MK2 User Manual - German - 16 pages

Denver WCT-5003MK2 Quick start guide - Dutch - 2 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Denver WCT-5003MK2 Manual

Product: