GET STARTED
This product is AC powered. Use two ‘AAA’ size batteries to keep time settings for power interruption.
Insert batteries by matching the polarity (+/-) markings in the battery compartment (8).
Replace all batteries at the same time with only new batteries. Remove all batteries when the product is not in use for
extended periods of time.
Plug the power cable (9) into an electrical outlet with correct voltage. DO NOT PLUG THE PRODUCT INTO AN
ELECTRICAL OUTLET IF YOU ARE UNSURE OF THE VOLTAGE.
USE INSTRUCTIONS
SETTING THE CLOCK
1. The time digits flash after connecting power to the product; or hold down the “TIME” button (7) for approximately 3
seconds until the time digits flash on the display.
2. Press the “HOUR” button (2) repeatedly to change the hour setting.
3. Press the “MIN” button (3) repeatedly to change the minute setting.
4. Press the “TIME” button (7) to confirm the settings.
USING ALARM
This product has dual alarms that can be set and used independently. The steps to set both alarms are the same. Follow
the instructions below to set alarm time 1. For alarm time 2, substitute “ALARM 1” button (5) with “ALARM 2” button (6).
1. Press and hold the “ALARM 1” button (5) to enter setting mode for alarm time 1.
2. When the digits are flashing, press the “HOUR” button (2) repeatedly to change the hour setting. Press the “MIN”
button (3) repeatedly to change the minute setting.
3. Press “ALARM 1” button (5) to confirm the settings. Alarm 1 is activated and indicator “A” is lit.
4. To activate or deactivate Alarm 1, press the “ALARM 1” button (5).
5. When the alarm sounds, press the “DIMMER HI/LOW SNOOZE” button (4) to enter snooze mode. Alarm will sound
again in 9 minutes.
6. Or when the alarm sounds, press the “AL/OFF” button (1) to turn off alarm.
Note: During clock and alarm settings, if there is no button operation for five seconds, time digits stop flashing and the
setting mode exits without new settings made.
ADJUSTING DISPLAY BRIGHTNESS
You can press the “DIMMER HI/LOW SNOOZE” button (4) to adjust display brightness when the alarm does not ring.
