615538
5
Zoom out
Zoom in
Previous page
1/6
Next page
To do an instant ip simply press the 360° Eversion button on the front of the controller,
the drone will ip forward 360°.
Warning: Do not perform a 360° ip unless the drone has enough space for safety.
Left Trigger
360° Eversion button
VIDEO AND CAMERA OPERATION
ENG-9 ENG-10
Camera
State LED
Micro-SD
Storage Card
Press the Mode button on lower right of the controller to switch between Flight
Mode 1 (maximum Gyro-stability) and Mode 2 (3D expert control). The LCD screen will
indicate the current mode.
Mode 1 automatically uses the 6-Axis Gyro (3 gyroscopes and 3 accelerometers) to its
full capabilities for stable, level ight. Use this mode for beginners, or to hover for
movies and snapshots.
Mode 2 tilts the drone more sharply (stronger pitch and roll), for faster acceleration.
Use this mode for racing and 3D maneuvers.
The drone can easily ip in an entire 360° circle. The drone will quickly stabilize and
level out, but will lose some altitude, so rst make sure the drone is ying high above
the ground.
To ip in the direction you choose, rst press the LEFT TRIGGER. The controller will
start beeping and enter 360° Flip Mode. Push the RIGHT STICK to ip in the desired
direction (forward, backward, left, or right) and return to normal ight. When the battery
runs low, the transmitter will activated a “di, di” sound alarm, the LED lights on the
drone will ash and the ip action will be auto turn off.
If the drone drifts to the side when
the stick is centered, click this switch
left or right until the drone is stable.
6. Adjust Left/Right Trim (Roll)
FLIGHT MODES
360° FLIPS
If the drone drifts forward or back
when the stick is centered, click this
switch forward or backward until
the drone is stable.
7. Adjust Forward/Backward Trim (Pitch)
1. If a storage card is not already installed, install a micro-SD ( “not included”) storage
card in the camera underneath the drone. See the small sketch on the camera itself,
which shows how to orient the chip correctly. Press the chip in until it clicks and stays.
2. To take a photograph, press the Camera Button on the front of the controller.The red
Camera State LED underneath the drone will blink on for about 2 seconds then off
indicating that the drone has taken a single, still photo.
3. To record video, press the Video Button on the front of the controller to start
recording. The red Camera State LED underneath the drone will come on to show
that video is being recorded. Press the Video Button against to stop recording.
Note: Always remember to stop the video recording with the controller before
shutting down. If the drone is switched off while still recording, the AVI le
being stored on the micro-SD card might not be “closed” or stored properly.
4. To quickly retrieve your videos and photos, connect the micro SD card reader
(included) to your computer. Optionally, you have remove the micro-SD storage card
and access the card directly with your computer. The data on the micro-SD card will
appear in folders as JPEG les and AVI les, which you can move to your computer.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denver DCH-600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denver DCH-600 in the language / languages: English as an attachment in your email.

The manual is 6,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Denver DCH-600

Denver DCH-600 User Manual - German - 6 pages

Denver DCH-600 User Manual - Dutch - 6 pages

Denver DCH-600 User Manual - French - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info