6
ENGLISH
ENGLISH
Getting Started Getting Started
Wipe gently from the
middle outwards.
Do not wipe with a
circular motion.
NOTE:
Do not use record spray or antistatic. Also
do not use volatile chemicals such as
benzene or thinner.
Record
spray
Thinner Benzene
Cleaning discs
• Fingerprints or dirt on the disc may lower
sound and picture quality or cause breaks in
playback. Wipe off fingerprints or dirt.
• Use a commercially available disc cleaning set
or a soft cloth to wipe off fingerprints or dirt.
Cautions on handling discs
• Do not get fingerprints, grease or dirt on
discs.
• Be especially careful not to scratch discs
when removing them from their cases.
• Do not bend discs.
• Do not heat discs.
• Do not enlarge the center hole.
• Do not write on the labeled (printed) side with
a ball-point pen or a pencil.
•Water droplets may form on the surface if the
disc is moved suddenly from a cold place to a
warm one. Do not use a hairdryer, etc., to dry
the disc.
Storing discs
• Always eject discs after playing them.
• Keep discs in their cases to protect them from
dust, scratches and warping.
• Do not put discs in the following places:
1. Places exposed to direct sunlight for long
periods of time
2. Humid or dusty places
3. Places exposed to heat from heaters, etc.
Loading discs
• Only load one disc at a time. Loading one disc
on top of another may result in damage or
scratch the discs.
• Load 8 cm discs securely in the disc guide,
without using an adapter. If the disc is not
properly loaded, it may slip out of the guide
and block the disc tray.
• Be careful not to let your fingers get caught
when the disc tray is closing.
• Do not place anything but discs in the disc
tray.
• Do not load cracked or warped discs or discs
that have been fixed with adhesive, etc.
• Do not use discs on which the adhesive part
of cellophane tape or glue used to attach the
label is exposed, or discs with traces of tape
or labels that have been peeled off. Such
discs may get stuck inside the player,
resulting in damage.
Operating range of the remote control unit
30°
30°
Approx. 7m / 22 feet
• Point the remote control unit at the remote sensor on the main unit as shown on the diagram.
• The remote control unit can be used from a straight distance of approximately 7 meters/22 feet
from the main unit, but this distance will be shorter if there are obstacles in the way or if the
remote control unit is not pointed directly at the remote sensor.
• The remote control unit can be operated at a horizontal angle of up to 30 degrees with respect
to the remote sensor.
NOTE:
• It may be difficult to operate the remote
control unit if the remote sensor is exposed to
direct sunlight or strong artificial light.
• Do not press buttons on the main unit and
remote control unit simultaneously. Doing so
may result in malfunction.
• Neon signs or other devices emitting pulse-
type noise nearby may result in malfunction,
so keep the set as far away from such devices
as possible.
