67709
15
Zoom out
Zoom in
Previous page
1/60
Next page

Setup Playback Remote Control Information Troubleshooting
ENGLISH
47*%&0
*/
7*%&0
$0.10/&/57*%&0
: 1# 13
7*%&0
*/
)%.*
*/ */
Monitor
The component video terminals may be indicated differently on your TV. For details, see the TV's operating
instructions.
Connecting the Monitor
Protector circuit
The protection circuit will be activated in the
following cases:
When the speaker output is short-circuited
When the temperature around the set is
extremely high
When the set is used for long periods of time
with a high output and the internal temperature
rises
When the protection circuit is activated, the
speaker output is cut off and the power supply
indicator ashes. Should this occur, please follow
these steps: be sure to switch off the power of
this unit, check whether there are any faults with
the wiring of the speaker cables or input cables,
and wait for the unit to cool down if it is very hot.
Improve the ventilation condition around the unit
and switch the power back on.
If the protection circuit is activated again even
though there are no problems with the wiring
or the ventilation around the unit, switch off the
power and contact a DENON service center.
Mounting the speaker stand and bracket
b Be sure to tighten the screws completely.
b Also be careful when installing.
Wall
Select and connect using one of the video cables below according to the TV's terminals. The terminals
provide playback with different picture qualities, in the following order (from highest to lowest):
qHDMI terminals, wComponent video terminals, eS-Video terminals, rVideo terminals
Switching the video output format
Set the HDMI/PROGRESSIVE/INTERLACED switch on the rear panel according to the video output format
of the TV connected to the set.
b Be sure to turn the power off before operating the switch.
Screws
(included)
Screws
(included)
Wall bracket
(included)
Speaker Stand
(included)
Anti slip pads here.
b When placing the speaker system (SC-S302) on a
stand, etc., stick the included cushion pads at the
two corners of the bottom surface. (Refer to the
illustration below.)
Getting Started Connections
Note on speaker impedance
If speakers with an impedance below the specified
impedance (4 Ω/ohms) are used (for example,
speakers with an impedance of 3 Ω/ohms) with
the volume turned up high for long periods of
time, the temperature may rise, activating the
protective circuit.
When the protection circuit is activated, the output
to the speakers is cut off and the power indicator
blinks. If this happens, unplug the power supply
cord, wait for the set to cool off and improve
ventilation around the unit. Also check the wiring
of the input cables and the speaker cables. After
doing this, plug the power supply cord back in and
turn the unit’s power back on.
If the protection circuit is activated again even
though there are no problems with the wiring
or the ventilation around the unit, switch off the
power and contact a DENON service center.
1.S-302E2_1st.indd 15 2007/07/30 20:00:48
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon S-302 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon S-302 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 6,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Denon S-302

Denon S-302 User Manual - Dutch - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info