444911
52
Zoom out
Zoom in
Previous page
1/60
Next page

Getting Started Connections Setup Playback Remote Control Information Troubleshooting
Getting Started Connections Setup Playback Remote Control Information
ENGLISH
If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owners manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Troubleshooting
Symptom Cause Countermeasure Page
Display not lit
and sound not
produced when
power switch set
to on.
Power cord not plugged in
securely.
Check the insertion of the power
cord plug.
10
Display lit but
sound not
produced.
Speaker cables not securely
connected.
Device you want to play and set
input source do not match.
Volume control set to minimum.
MUTING is on.
Digital signals not input Digital
input selected.
Connect securely.
Select an appropriate input
source.
Turn volume up to suitable level.
Switch off MUTING.
Input digital signals or select
input terminal to which digital
signals are being input.
10
24
24
40
13
Monitor does not
display an image.
Connections between the video
output terminal of this unit
and the input connector of the
monitor are incomplete.
The input setting of the monitor
TV is different.
Check whether the connections
are correct.
Set the input switching of the
TV to the terminal to which the
video input is connected.
11
11
When the
subwoofer
indicator has lit.
The subwoofer and main unit are
not properly connected with the
system cable.
Check whether or not the cable
is properly connected.
If the indicator lights even though
the cable is properly connected,
there may be a malfunction.
10
GGeneralH
Symptom Cause Countermeasure Page
Power turns off
suddenly and
power indicator
flashes red.
Protection circuit activated due
to rise of internal temperature.
Core wires of two speakers are
touching each other or a core
wire is sticking out of the terminal
and touching the set’s rear panel,
activating the protection circuit.
Set is damaged.
Turn off the power, wait for the
set to fully cool down, then turn
the power back on.
Place the set in a well-ventilated
place.
First unplug the power cord,
then twist the core wires tightly
or terminate the speaker cables,
then reconnect.
Turn off the power and contact a
DENON service center.
11
11
9
GRemote Control UnitH
Symptom Cause Countermeasure Page
Set does not work
properly when
remote control
unit operated.
Batteries are worn.
You are operating outside of the
specified range.
Obstacle between main unit and
remote control unit.
The batteries are not inserted in
the proper direction, as indicated
by the polarity marks in the
battery compartment.
The set’s remote control sensor
is exposed to strong light (direct
sunlight, inverter type fluorescent
bulb light, etc.).
SOURCE CONTROL switch position
is different.
Replace with new batteries.
Operate within the specified
range.
Remove the obstacle.
Insert the batteries in the
proper direction, following the
polarity marks in the battery
compartment.
Move the set to a place in which
the remote control sensor will
not be exposed to strong light.
Set the SOURCE CONTROL switch
for the device you wish to use.
5
5
5
5
5
8
Troubleshooting
1.S-302E2_1st.indd 52 2007/07/30 20:01:54
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon S-03 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon S-03 in the language / languages: Dutch as an attachment in your email.

The manual is 6,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info