Color component output connectors (PR/CR, PB/CB and Y)
The red (P
R/CR), blue (PB/CB) and brightness (Y) signals are output independently,
achieving more faithful reproduction of the colors.
• The color component input connectors may be marked differently on some TVs or
monitors (P
R, PB and Y/R-Y, B-Y and Y/CR, CB and Y, etc.). For details, refer to the TV’s
operating instructions.
• Connect in this way if your TV is compatible with Progressive Scan.
DVD-2910
To power outlet
NOTES:
• Use the three commercially available video cords to connect the DVD-2910’s color component output
connectors to the TV or monitor.
• Set the “TV TYPE” in “VIDEO SETUP” in “SETUP” to comply with your TV’s video format. When the TV
is PAL formated, set to PAL. (See page 18.)
• Set the “VIDEO OUT” in “VIDEO SETUP” in “SETUP” to comply with Progressive TV.
• To use with 5.1ch audio output, set “2CH (SRS OFF)” or “2CH (SRS ON) ” in “AUDIO CHANNEL” in
“AUDIO SETUP” in “SETUP” at the initial settings. (See page 19.)
• Set the “TV ASPECT” in “VIDEO SETUP” in “SETUP” to comply with your TV’s aspect. (See page 18.)
TV
CONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION TELEVISION SETS ARE FULLY COMPATIBLE
WITH THIS PRODUCT AND MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE. IN CASE OF
525 OR 625 PROGRESSIVE SCAN PICTURE PROBLEMS, IT IS RECOMMENDED THAT THE USER
SWITCH THE CONNECTION TO THE “STANDARD DEFINITION” OUTPUT.
(3) Connecting to a TV with 21-pin SCART Terminal (For only European model)
• Use the commercially 21-pin SCART cable to connect the TV’s 21-pin SCART terminal to the DVD-2910’s 21-
pin SCART terminal (AV1).
DVD-2910
To power outlet
TV
21-pin SCART terminal
• Set the “TV TYPE” in “VIDEO SETUP” in
“SETUP” to comply with your TV’s video format.
When the TV is PAL formated, set to PAL. (See
page 18.)
NOTES:
•
Some discs contain copy prohibit signals. If such
discs are played via a VCR, the copy prohibit
system may cause disturbance in the picture.
• To improve picture quality, you can change the video signal output from the AV1 terminal from “Video” to
either “S-Video” or “RGB” to suit the type of television you are using (See page 18.).