ENGLISH
ENGLISH
10
If a problem should arise, first check the following:
1. Are the connections correct ?
2. Have you operated the player according to the Operating Instructions ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction. Disconnect the power immediately and contact your store of purchase.
PageMeasures CauseSymptom
Disc tray does not open. • The power is not on. • Turn on the power. 7
“NO DISC” is displayed
even though a disc is loaded.
•The disc is not properly loaded. • Reload the disc. 2, 3
Disc is not played when play
button is pressed.
• The disc is dirty or scratched. • Wipe the dirt off the disc or replace
the disc.
3
No sound is produced or
sound is distorted.
• The output cables are not properly
connected to the amplifier.
• The amplifier’s function setting or
adjustments are not right.
• Check the connections.
• Check the amplifier’s function and
controls and adjust as necessary.
6
–
No digital signals are output. • The connection cables are not
properly connected.
• Check the connections. 6
Specific section of the disc
cannot be played properly.
• The disc is dirty or scratched. • Wipe the dirt off the disc or replace
the disc.
3
Programmed playback is not
possible.
• The tracks have not been
programmed properly.
•Program properly. 8
A CD-R or CD-RW disc
cannot be played.
• The disc has not been finalized.
• The recording conditions are bad or
the quality of the disc itself it poor.
• Finalize the disc then play it.
• Use a properly recorded disc.
2
2
Set does not operate
properly when remote
control unit is operated.
• The batteries are spent.
• The remote control unit is too far
from the set.
• Replace the batteries with new
ones.
•Move the remote control unit closer
to the set.
3
3
Troubleshooting
Others
¢ Audio performance
• Analog output
Channels: 2 channels
Playable frequency range: 2 Hz ~ 20 kHz
S/N: 105 dB
Dynamic range: 98 dB
Harmonic distortion: 0.003 % (1 kHz)
Wow & flutter: Below measurable limits
Output level: 2.0 V (10 kΩ/kohms)
Signal type: 16-bit linear PCM
Sampling frequency: 44.1 kHz
Usable discs: Compact Disc
• Digital output
Optical: –15 ~ –21 dBm
Emission wavelength: 660 nm
¢ General
Power supply: AC 230 V, 50 Hz
Power consumption: 13 W
Maximum external dimensions: 434 (W) x 107 (H) x 279 (D) mm (including protruding parts)
Mass: 4.0 kg
¢ Remote control unit (RC-1028)
Remote control type: Infrared pulse
Batteries: R03/AAA Type (two batteries)
External dimensions: 49 (W) x 220 (H) x 21 (D) mm
Mass: 106 g (included batteries)
* For purposes of improvement, specifications and design are subject to change without notice.
Specifications
“00 00 : 00” is displayed
even though a disc is loaded.
• The loaded disc is not a CD. • Load a CD. 2
