370600
9
Zoom out
Zoom in
Previous page
1/69
Next page
ENGLISH
9
(3) Connecting Antennas
The high-performance AM loop antenna provided
with this unit is sufficient for good reception in most
areas.
To stand the loop antenna on a surface, fix the claw
to the slot.
Connect the loop antenna's wires to the AM antenna
terminals as shown.
(Connect the white wire to the upper terminal, and
the black wire to the lower terminal.)
Place the antenna on a shelf, for example, or hang it
on a window frame, etc., in the direction which gives
the best reception, as far away as possible from the
entire system, speaker cords and the power cord, to
prevent unwanted noise.
If there is no room for the AM loop antenna, you may
mount it on the wall using screws (not supplied).
A
AM Indoor Loop Antenna
B
AM Outdoor Antenna
If the AM loop antenna provided does not deliver
sufficient reception (often due to being too far from
the transmitter or in a concrete building, etc.), it may
be necessary to use an outdoor AM antenna.
Use an insulated wire more than 15 ft (5 m) long,
strip one end, and connect this to the terminal as
shown.
The antenna wire should be strung outdoors or
indoors near a window. For better reception, connect
the GND terminal to a reliable ground.
Note:
Even when using an outdoor AM antenna, do not
disconnect the AM loop antenna.
AM Antenna
ADV-500SD
BLACK
WHITE
A
B
C
FM Indoor Antenna
Connect the lead-type FM antenna to the FM 75
socket, extend the lead and fix it to a window frame
or wall with thumbtacks, or the like, where reception
is best.
D
FM Outdoor Antenna
In an area where FM signals are weak, it will be
necessary to use an outdoor FM antenna.
Generally, a 3-element antenna will be sufficient; if
you live in an area where the FM signals are
particularly weak, it may be necessary to use one
with 5 or more elements.
8
PART NAMES AND FUNCTION
(1) Front Panel
q POWER (ON/STANBY) switch
Press this switch to turn the unit on or off
(standby).
w Disc tray
e OPEN/CLOSE (5) button
Use this button to open and close the disc
tray.
r FUNCTION (DVD, TUNER, VIDEO1,
VIDEO2, TV) button
• This button is used to select a function.
t SURROUND MODE button
• Use this button to select a surround mode.
y PROGRESSIVE SCAN button
Press this to switch the component video
output between PROGRESSIVE and
INTERLACED SCAN.
u PLAY (1)/BAND button
In DVD mode, use this button to start
playback.
• In TUNER mode, use this button to select FM
or AM.
In TUNER mode, press this button for more
than 2 seconds to alternate between Tuning
mode and Preset mode.
i PAUSE/STEP (3)/MEMORY button
Pause playback or recording temporarily /
press repeatedly for frame-by-frame playback.
In TUNER mode, use this button to memory
the preset channels.
o STOP (2)/FM MODE button
In TUNER mode, press this button to select
stereo or monoral mode, while listening to FM
broadcasts.
In TUNER mode,use this button to clear
Preset Memory.
• In DVD mode, stops playback.
!0 TONE/DIMMER button
This button is used to adjust BASS and
TREBLE, or to dim the display. Press this
button repeatedly to select BASS, TRE or DIM,
and then turn the VOLUME dial to adjust.
!1 SKIP (8, 9)/TUNING buttons
In DVD mode, use these buttons to skip
chapters or tracks.
• During PBC playback of a VCD, these buttons
are used to advance the menu page.
• In TUNER mode, use these buttons to tune in
a station.
!2 VOLUME Dial
Turn the VOLUME dial to adjust the master
volume.
!3 Display
• When the unit is on, the current status of the
unit is displayed.
!4 STANDBY indicator
This indicator lights when the unit is in the
standby mode.
When the unit is turned on, it goes off.
!5 PHONES
For private listening, insert the headphones
plug into this jack, and adjust the volume by
turning the VOLUME knob.
!6 REMOTE SENSOR
• When operating the remote control unit, point
it towards the REMOTE SENSOR.
STANDBY
DVD
D
EX
TITLE CHP
DVD SURROUND RECEIVER ADV-500SD
PHONES
MASTER VOLUME
/SELECT
MEMORYBAND FM MODE
TONE/DIMMER
FUNCTIONON/STAND
TUNING
PROGRESSIVE
SCAN
SURROUND
MODE
qw
e
r
t
y
u
i
o!0
!1
!3
!2
!4!5!6
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon dht-500sd at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon dht-500sd in the language / languages: German as an attachment in your email.

The manual is 4,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Denon dht-500sd

Denon dht-500sd User Manual - English - 37 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info