NOTE
•The dedicated driver must be installed in the computer before this unit is connected
to a computer. Operation will not occur correctly if connected to the computer
before the dedicated driver has been installed. Moreover, if the computer is
running Windows XP as its OS, the computer’s speed will decrease significantly,
and a computer restart may be required.
•Operation may fail in some computer hardware and software configurations.
2 Computer (recommended system)
OS
•Windows® XP Service Pack3, Windows® Vista, Windows 7 or Windows 8
•Mac OS X 10.6.4 or later.
Software
•Server software supporting Windows Media® Player and iTunes.
USB
•USB 2.0: USB High speed/USB Audio Class Ver.2.0
2 Playback
Install the desired player software on your computer beforehand.
Use the rear panel USB port to connect this unit to a computer. For
the connection procedure, refer to the “Connecting a PC or Mac”
(vpage21) section.
1
Press SOURCE to change the input source to “USB-
DAC”.
Start playback on the computer’s player software.
The input digital audio signal is displayed as shown.
“USB : xxxxxk“
or
“USB : DSD xxxM“
(xxxx is the sampling frequency.)
•The L.PCM indicator lights when a Linear PCM signal is detected.
•If the sampling frequency cannot be detected, “Unlock” will be
displayed.
•When “USB : xxxx” is displayed on this unit, wait for
approximately 10 seconds, and then start and operate the
music playback software on the computer. This unit functions
as a D/A converter.
2 Files that can be played back
•See “D/A converter” (vpage61).
NOTE
If the computer you use is “Mac OS”, please check if the ”USB High
Speed Audio” format is set below ”192000.0 Hz” using the ”Audio MIDI
Setup”.