139630
7
Zoom out
Zoom in
Previous page
1/58
Next page
2
Introduction Connections Playback Function Setup Others
ENGLISH
ENGLISH
Introduction
Use only discs marked with logos listed on page 4.
The main power supply is engaged when the main plug is
plugged in a 110-240V, 50/60Hz AC outlet. To operate the unit,
press [POWER ON] or <ON/STANDBY> to turn on the unit.
To avoid fire or electric shock, do not expose this unit to rain or
moisture.
For safety and optimum performance of this unit:
Do not stand the unit up vertically. Install the unit in a horizontal
and stable position. Do not place anything directly on top of the
unit. Do not place the unit directly on top of the TV.
Shield it from direct sunlight and keep it away from sources of
intense heat. Avoid dusty or humid places. Avoid places with
insufficient ventilation for proper heat dissipation. Do not block
the ventilation holes on the sides of the unit. Avoid locations
subject to strong vibration or strong magnetic fields.
Be sure to remove a disc and unplug the AC cord from the outlet
before carrying the unit.
Noise or disturbance of the picture may be generated if this unit or
any other electronic equipment using microprocessors is used
near a tuner or TV.
If this happens, take the following steps:
Install this unit as far as possible from the tuner or TV.
Set the antenna wires from the tuner or TV away from this unit’s
AC cord and input/output connection cords.
Noise or disturbance tends to occur particularly when using
indoor antennas or 300/ohms feeder wires. We recommend
using outdoor antennas and 75/ohms coaxial cables.
Cautions on using mobile phones.
Using a mobile phone near this unit may result in noise. If so,
move the mobile phone away from this unit when it is in use.
Before turning the power operation button on.
Check once again that all connections are correct and that there
are no problems with the connection cables. Always set the
power operation button to the standby position before
connecting and disconnecting connection cables.
Sufficiently ventilate the place of installation.
If the unit is left in a room full of the smoke from cigarettes, etc.,
for long periods of time, the surface of the optical pickup could
get dirty, in which case it will not be able to read the signals
properly.
Moisture condensation may occur inside the unit when it is
moved from a cold place to a warm place, or after heating a cold
room or under conditions of high humidity. Do not use the unit at
least for 2 hours until its inside is dry.
Do not handle the AC cord with wet hands.
Do not pull on the AC cord when disconnecting it from AC wall
outlet. Grasp it by the plug.
If, by accident, water is spilled on this unit, unplug the AC cord
immediately and take the unit to our authorised service centre
for servicing.
Pay attention to the following before using this unit:
Moving the unit.
To prevent short-circuits or damaged wires in the connection
cables, always unplug the power supply cord and disconnect the
connection cables between all other audio components when
moving the unit.
Store the owner’s manual in a safe place.
After reading the owner’s manual, store it in a safe place as it
could come in handy in the future.
Whenever <ON/STANDBY> is in the STANDBY state, the unit
is still connected to AC line voltage.
Please be sure to unplug the cord when you leave home for, say,
a vacation.
Note that the illustrations in these instructions may differ
from the actual unit for explanation purposes.
Unauthorised copying, broadcasting, public performance and
lending of discs are prohibited.
This product incorporates copyright protection technology that is
protected by U.S. patents and other intellectual property rights.
Use of this copyright protection technology must be authorised
by Macrovision, and is intended for home and other limited
viewing uses only unless otherwise authorised by Macrovision.
Reverse engineering or disassembly is prohibited.
Important
Power Supply
Warning
WARNING:
LIVE PARTS INSIDE.
DO NOT REMOVE ANY SCREWS.
Installation Location
Non-use periods - Turn off the unit when it is not in use. Unplug
the unit from the household AC outlet if it is not to be used for a
long time. Unplug the unit during lightning storms.
Please read this owner’s manual carefully before using the unit,
and keep it for future reference.
Cautions on Installation
Note
For heat dispersal, do not install this equipment in a
confined space such as a book case or similar unit.
Cautions on Handling
Dew Warning
ON / STANDBY
SD CARD
10 cm or more
Wall
Avoid the Hazards of Electrical Shock and Fire
Before Using
About Copyright
U. S. Patent No’s, 6,836,549; 6,381,747; 7,050,698;
6,516,132 and 5,583,936.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon dbp 2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon dbp 2010 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 6,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info