1
2
Press the power ON/SOURCE button and the OFF button at
the same time.
• The LEARNED/TX indicator flashes.
Press the mode button of the equipment that is to be entered
to a preset memory.
• The mode button flashes.
3
4
5
When stored correctly, the mode button and the
LEARNED/TX indicator will light.
Referring to the included List of
Preset Codes, use the number
buttons to input the preset code (a
4-digit number) for the
manufacturer of the component
whose signals you want to store in
the memory.
To store the codes of another component in the memory,
repeat steps 1 to 4.
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR ........................................................................HITACHI
CD, TAPE .....................................................................DENON
CDR/MD.......................................................................DENON (CDR)
DVD/VDP......................................................................DENON (DVD)
DBS/CABLE .................................................................ABC (CABLE)
NOTES:
• Depending on the model and year of manufacture, this function cannot be used for some models, even if the your device is listed on the
included list of preset codes.
• Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and
check it out.
• The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP and DBS/CABLE.
The included remote control unit can be used to operate devices of different brands by registering the preset number corresponding to the brand
of your device.
For some models the remote control unit or the device may not operate properly. In this case, use the learning function (page 53) to store your
device’s remote control signals in the included remote control unit.
