1Only the front speakers (A) is measured. Even if the
front speakers (B) is set, the setting automatically switches to the front speakers (A) once measurements are completed.
2Subwoofer speaker is measured twice.
3When “ZONE2” is selected, this is not displayed.
After each channel is measured, “Calculating” appears.
The display switches to Auto Setup check screen automatically.
NOTES:
•Measurement is canceled when MASTER VOLUME is operated
while the Auto Setup is performed.
•Set the volume to halfway and set the crossover frequency to
the maximum or Low pass filter off if your subwoofer speaker
can adjust the output volume and the crossover frequency.
About automatic retry
Remeasurement starts automatically to receive proper result of measurement.
Remeasurement is performed to 2 times, and “Retry1” or “Retry2” is displayed on screen during
remeasurement.
About the error message
These error screens will be displayed when performing the measurements of Auto Setup and the automatic measurements can not be completed
because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinent items,
and measure again.
When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the measurements when
the noise level is low, or switch off the power of the equipment that is producing the noise for the duration of the measurements.
qThis screen will be displayed when the speakers required for
producing suitable reproduction have not been detected.
•The front L and front R speakers were not properly detected.
•Only one channel of the surround speakers was detected.
•Sound was output from the R channel when only one surround
back speaker was connected.
•The surround back was detected, but the surround speaker was
not detected.
Check that the pertinent
speakers are properly
connected (see page 15).
wThis screen will be displayed when the speaker polarity is connected
in reverse.
Check the polarity of the
pertinent speakers.
For some speakers, the
screen below may be
displayed even though
the speakers are properly
connected.
If so, select “Skip0”.
eThis screen will be displayed when accurate measurements
cannot be made due to the input level to the microphone being
too high.
Set up the speakers so
that their position is
farther away from the
listening position.
Lower the volume of the
subwoofer speaker.
rThis screen will be displayed when the measurement microphone
is not connected, or when all of the speakers have not been
detected.
Connect the measurement microphone to the microphone
connector.
Check the speaker connections.
23
