584384
69
Zoom out
Zoom in
Previous page
1/84
Next page
69
15
TROUBLESHOOTING
If a problem should arise,first check the following.
1. Are the connections correct ?
2. Have you operated the receiver according to the Operating Instructions ?
3. Are the speakers, turntable and other components operating property ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
Disconnect the power immediately and contact your store of purchase.
Symptom Cause Measures Page
DISPLAY not lit and sound not produced
when power switch set to on.
Power cord not plugged in securely. Check the insertion of the power cord plug.
7
DISPLAY lit but sound not produced.
Speaker cords not securely connected.
Input source selector button position is not
appropriate.
Volume control set to minimum.
MUTING is on.
No digital signal is being input.
Speaker A or B button is set to OFF.
Connect securely.
Switch to the proper position.
Turn volume up to suitable level.
Switch off MUTING.
Properly select a digital signal input source.
Set the button for the connected speaker
terminals to ON.
13, 14
39
40
41
29
20
Nothing is displayed on monitor.
AVR-5803s video output jacks and monitors
input jacks are not properly connected.
Monitor TVs input setting is wrong.
Connections of the various components video
signals are not unified.
Check that the connections are correct.
Set the TVs input selector to the jacks to which
video signals are connected.
Unify to composite or S jack.
8 ~ 10
8 ~ 10
8 ~ 10
No dts sound is produced.
DVD players audio output setting is not set to bit
stream.
DVD player is not dts-compatible.
AVR-5803s input setting is set to analog.
Make the DVD players initial settings.
Use a dts-compatible player.
Set to AUTO or dts.
39
Copying from DVD to VCR is not
possible.
Mode video software contains copy prohibit
signals.
Copying is not possible.
No sound is produced from subwoofer.
Subwoofers power is not on.
Subwoofers initial setting is set to NO.
Subwoofers output is not connected.
Turn on the power.
Set the setting to YES.
Connect properly.
20
14
No test tones are produced.
Surround mode is set to a mode other than
Dolby Surround.
Set to Dolby Surround.
No sound is produced from surround
speakers.
Surround mode is set to STEREO. Set to a mode other than STEREO.
Dolby Digital is not possible with LDs.
Not connected to Dolby Digital jacks. Connect the LD players Dolby Digital RF output to
the AVR-5803s Dolby Digital RF input jacks.
8
This unit does not operate properly when
remote control unit is used.
Batteries dead.
Remote control unit too far from this unit.
Obstacle between this unit and remote control
unit.
Different button is being pressed.
< and > ends of battery inserted in reverse.
Replace with new batteries.
Move closer.
Remove obstacle.
Press the proper button.
Insert batteries properly.
37
37
37
37
Ultra2 Cinema/THX MusicMode cannot
be set.
Surround back speaker set to 1. Connect two surround back speakers.
18, 20, 27
69


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon AVR-5803 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon AVR-5803 in the language / languages: English as an attachment in your email.

The manual is 4,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info