• To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +12
dB in steps of 2 dB.)
• To decrease the bass or treble: Turn the control clockwise.
(The bass or treble sound can be decreased to up to –12
dB in steps of 2 dB.)
2If you do not want the bass and treble
to be adjusted, turn on the tone defeat
mode.
2 The signals do not pass through the
bass and treble adjustment circuits,
providing higher quality sound.
[3] Turning the sound off temporarily (muting)
1Use this to turn off the audio output
temporarily.
Press the MUTING button.
2 Cancelling MUTING mode.
Press the MUTING button again.
[4]
Combining the currently playing sound with the desired image
1Simulcast playback
Use this switch to monitor a video
source other than the audio source.
Press the VIDEO SELECT button
repeatedly until the desired source
appears on the display.
2Cancelling simulcast playback.
[5] Checking the currently playing program source, etc.
1On screen display
•
Each time an operation is performed, a
description of that operation appears
on the display connected to the unit’s
VIDEO MONITOR OUT jack. Also, the
unit’s operating status can be checked
during playback by pressing the remote
control unit’s ON SCREEN button.
Such information as the position of the
input selector and the surround
parameter settings is output in
sequence.
[2] Listening over headphones
Plug the headphones’ plug into the jack.
2 Connect the headphones to the PHONES jack.
The pre-out output (including the speaker output) is automatically
turned off when headphones are connected.
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
(Remote control unit)
Using the dimmer function
• Use this to change the brightness of the display.
The display brightness changes in four steps
(bright, medium, dim and off) by pressing the
remote control unit’s DIMMER button
repeatedly.
2 The brightness changes in 3 steps each time the
button is pressed, and finally the display turns
off.
