498716
6
Zoom out
Zoom in
Previous page
1/144
Next page
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsGetting Started
ENGLISH
Perform the operations leading to playback on the AVR-4810 in the
order shown below.
Audyssey™ Auto Setup (vpage 31)
Connections
Installing the Speakers
(vpage 11)
Speaker Connections (vpage 14)
Connecting Devices (vpage 17)
Turning the Power On (vpage 27)
Settings
Manual Setup (vpage 38)
Perform “Manual Setup” as necessary.b
Source Select (vpage 56)
Playback
Playing Components (vpage 64)
Selecting the Surround Mode (vpage 78)
Adjusting the Sound and Picture Quality
(vpage 81)
Flow of Operations Through
Playback
Cautions on Handling
Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When traveling or leaving home for long
periods of time, be sure to unplug the power cord from the power
outlet.
About condensation
If there is a major difference in temperature between the inside of
the unit and the surroundings, condensation (dew) may form on
the operating parts inside the unit, causing the unit not to operate
properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
Moving the unit
Turn off the power and unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units before
moving the unit.
Note that the illustrations in these instructions may differ from the
actual unit for explanation purposes.
Cautions on Installation
Note:
For proper heat dispersal, do not install this unit in a confined
space, such as a bookcase or similar enclosure.
b
b Note
b b
Getting Started
List of preset codes ··································End of this manual
Wall
Operating the Connected Devices by Remote
Control Unit············································································99
Operating the Main Remote Control Unit ································99
Operating AV Equipment ····························································99
Presetting ·················································································100
Operating Preset Components ·················································101
Setting the Remote ID ······························································104
Learning Function ·····································································104
MACRO Function······································································105
Punch Through Function ···························································106
Setting the Time the Backlight Stays Lit ···································106
Adjusting the Backlight’s Brightness ········································106
Specifying the Zone Used
with the Main Remote Control Unit ··········································107
Resetting the Main Remote Control Unit ·································107
Operating the Sub Remote Control Unit ································108
Switching Zones ·······································································109
Switching the Multi-zone Input Source to the Same
Input Source as Used in the MAIN ZONE ································109
Setting the Zone for Which the Sub Remote Control Unit
is Used (ZONE SELECT LOCK Mode) ······································109
Setting the Remote ID ······························································109
Resetting the Settings ······························································109
Other Information ·····························································110
Troubleshooting·································································120
Restoring All the Settings to as They were at the Time of
Purchase (Resetting the Microprocessor) ·······························123
Specifications ······································································124
Getting Started
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon AVR-4810 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon AVR-4810 in the language / languages: English as an attachment in your email.

The manual is 25,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Denon AVR-4810

Denon AVR-4810 User Manual - German - 144 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info