38
Learning function
If your AV component is not a Denon product or if it cannot be operated using the preset memory, it can be controlled with the accessorious
remote control unit by storing its remote control signals in the remote control unit.
For some remote control signals it is not possible to “learn” the signals or the device will not operate properly. In such cases use the remote
control unit included with the device to operate it.
1Press the power ON/SOURCE button and the OFF button
simultaneously.
•“PRE” appears on the remote control unit’s display.
2Use the •and ªcursor buttons to display “LRN” on the
remote control unit’s display, then press the ENTER button.
•“SEL” is displayed.
3Use the •and ªcursor buttons to select the mode for the
button to be “learned”, then press the ENTER button.
•“KEY” is displayed.
4Press the button to be “learned” while “KEY” is displayed.
“START” appears.
•“AGAIN” is displayed if a button that cannot be “learned”
is pressed.
•To cancel, press the power ON/SOURCE button and the
OFF button simultaneously.
5Point the remote control units directly at each other and press
and hold in the button on the other remote control unit which
you want to “learn”.
6“OK” appears on the remote control unit’s display and
learning is completed.
•“KEY” is displayed. Other keys can be “learned” by
repeating steps 4 to 6.
7The mode can be switched by pressing a mode button while
the “KEY” indicator is lit.
When the “ENTER” button is pressed, the “KEY” display
reappears and the learning standby mode is set.
Other remote
control unit
8To cancel the learning mode, press the power ON/SOURCE
button and the OFF button simultaneously again.
Registering is not possible in the receiver mode.