584055
22
Zoom out
Zoom in
Previous page
1/78
Next page
9
ENGLISH
Getting Started Connections Playback Remote Control Information Troubleshooting SpecificationsMulti-ZoneSettings
Connecting Devices not Equipped with HDMI terminals
Connections
REMOTE CONTROL jacksn
"69
065
External Controller
RS-232C connector
When you connect an external control device, you can control
the AVR-2310CI with the external control device. Perform
the operation below beforehand.
q Turn on the AVR-2310CI’s power.
w Turn off the AVR-2310CI’s power from the external
controller.
e Check that the AVR-2310CI is in the standby mode.
n
When using the AVR-2310CI in combination with the DENON RF
remote controller (RC-7000CI, sold separately) or RF remote receiver
(RC-7001RCI, sold separately), two-way communication is enabled.
The AVR-2310CI’s status information as well as iPod and Internet audio
music files can be browsed watching the RF Remote Controllers
display. For details, refer to the operating instructions of the respective
devices.
TRIGGER OUT jacks
The TRIGGER OUT output terminal outputs a maximum 12
V/150 mA electrical signal. When a device with TRIGGER IN
terminal is connected via a monaural mini-plug, the connected
device’s power on/standby can be controlled through linked
operation to the AVR-2310CI.
n
Set this to use the RS-232C connector for the DENON RF remote
controller.
“232C Port” (vpage 35)
Set as Necessary
Set to change the conditions for linked operation via the TRIGGER
OUT terminal.
“Trigger Out” (vpage 35)
Set as Necessary
NOTE
On the GUI menu, when setting “232C Port” to “2Way Remote, you
cannot use the RS-232C connector as an external controller (vpage
35).
Extension jack for future use.
(Connect devices corresponding
with room to room function to
this jack.)
Infrared
retransmitter
Input Output
Infrared
sensor
NOTE
Insert the AC plugs securely. Incomplete connections could cause
noise.
Only use the AC outlets to plug in audio equipment. Do not use
them as power supplies for hairdryers or anything other than audio
equipment.
Wait until all connections have been completed before connecting the
power cord.
To household
power outlet
(AC 120 V, 60 Hz)
Power cord
Connection to the AC outlets
These outlets supply power to external au-
dio equipment.
Audio equipment with a total power con-
sumption of 120 W (1 A) can be connect-
ed.
The power supply turns on and off together
with the on the main unit. When set
to “ON”, power is supplied from the outlet.
When set to “STANDBY”, no power is sup-
plied.
NOTE
When “HDMI Control” (vpage 31) is set
to ON”, power is supplied constantly to
the AC outlet (UNSWITCHED).
Connecting the Power Cord
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon AVR-2310CI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon AVR-2310CI in the language / languages: English as an attachment in your email.

The manual is 15,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Denon AVR-2310CI

Denon AVR-2310CI Quick start guide - English - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info