ENGLISH
43
ENGLISH
¢ Last function memory
The various settings set when the AVR-1507’s power is switched to
standby are stored in the memory. When the power is turned back on,
the settings made when the power was switched to standby are
recalled.
About the memory functions
Recording the program source (recording the
source currently being monitored)
¢ Backup memory
The various settings are stored in the memory for about 1 week, even
when the power is turned off or the power cord is unplugged.
Advanced Operation Advanced Operation
Initialization of the microprocessor (Reset)
If the indication on the display is not normal or if the operation of the
unit is not correct, then the microprocessor should be reset by the
following procedure.
Switch off the unit using <POWER>.
1
Check that the entire display is flashing at 1-second
intervals and release the buttons.
• The microprocessor will be initialized.
3
Keep both <SPEAKER> (A and B) depressed and turn
on the unit by pressing
<POWER>.
2
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from the
factory).
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
Select the input source to be played.
1
Start recording on the tape or video deck.
For instructions, refer to the component’s operating instructions.
3
Select the input mode and play (surround) mode.
2
• The AUDIO IN’s signal selected with INPUT SELECTOR are output to
the CD-R/TAPE and VCR AUDIO OUT terminals.
• Digital signals are not output to the audio output terminals.
¢ Simultaneous recording
The signals of the source selected with INPUT SELECTOR are output
simultaneously to the CD-R/TAPE and VCR REC OUT terminals. If a
total of two tape and/or video decks are connected and set to the
recording mode, the same source can be recorded simultaneously on
every decks.