3
IMPORTANT SAFEGUARDS
When using electrical appliances, basic precautions should always be followed to reduce risk of fire, electric
shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. If your appliance is equipped with a polythene tape used as carry handle, remove it before connecting
appliance to the outlet.
3. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handle when
moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and
curtains at least 3 feet (0,9 m) from the front and top of the heater and keep them away from the sides
and rear.
4. Extreme caution is necessary when any heater is used by or near children and whenever the heater is left
operating and unattended.
5. Always unplug heater when not in use.
6. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been
dropped or damaged in any manner. If heater has leaked any oil, discontinue using the heater and
contact the service center as indicated in the instruction leaflet. Return heater to authorized service faci-
lity for examination, electrical or mechanical adjustment, or repair.
7. Do not use outdoors.
8. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never loca-
te heater where it may fall into a bathtub or other water container.
9. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange
cord away from traffic area and where it will not be tripped over.
10. To disconnect heater, turn controls to off, then remove plug from outlet.
11. Connect to properly polarized outlets only.
12. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an
electric shock, fire, or damage the heater.
13. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces,
like a bed, where openings may become blocked.
14. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
15. Use this heater only as described in this manual. Any other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons.
16. To prevent overload and blown fuses, be sure that no other appliance is plugged into the same outlet
(receptacle) or into another outlet (receptacle) wired into the same circuit.
17. It is normal for the heater’s plug and cord to feel warm to the touch. A plug or cord which becomes hot to
the touch or becomes distorted in shape may be a result of a worn electrical outlet. Worn outlets or recep-
tacles should be replaced prior to further use of the heater. Plugging heater into a worn outlet /recepta-
cle/ may result in overheating of the power cord or fire.
18. Do not use an extension cord because it may overheat and cause a risk of fire. However, if you have
to use an extension cord, the cord shall be No. 1 4 AWG minimum size and rated not less than 1875
watts, and has to be used only for supplying power to this heater.
19. Be sure that the plug is fully inserted into an appropriate outlet. Please remember that outlets also deterio-
rate due to aging and continuous use: check periodically for signs of overheating and deformations of the
plug. Do not use the outlet and CALL your electrician if these signs are present.
20. Check that neither the appliance nor the power cable have been damaged in any way during transportation.
21. Make sure that no pieces of polystyrene or other packaging material have been left between one element
of the appliance and another. It may be necessary to pass over the appliance with a vacuum cleaner.
22. When switching on the appliance for the first time, allow it to run at full power for about two hours to
get rid of the unpleasant smell. Make sure that the room in which the appliance is located is well venti-
lated during this operation. It is normal for the appliance to emit small cracking sounds when you turn
it on for the first time.
23.CAUTION: to prevent electric shock match wide blade of plug to wide slot, fully insert.
24.Do not cover the appliance while it is functioning in order to avoid overheating with the possible
risk of fire.
SAVE THESE INSTRUCTIONS
