686495
13
Zoom out
Zoom in
Previous page
1/31
Next page
18
13.1 Tips for using steam to froth milk
When choosing the size of the container, bear in mind that
the liquid doubles or triples in volume.
For a richer denser froth, use skimmed or partially skimmed
milk at refrigerator temperature (about 5°C).
For a creamier froth, rotate the container with slow move-
ments in an upward direction.
To avoid milk with poor froth or large bubbles, always clean
the spout (C6) as described in the following section.
13.2 Clean the hot water/steam spout after use
Always clean the hot water/steam spout (C6) after use to avoid
the build-up of milk residues and prevent it from clogging.
1. Place a container under the hot water/steam spout and de-
liver a little water (see section “12. Delivering hot water”).
Stop delivery of hot water by pressing " ".
2. Wait a few minutes for the hot water/steam spout to cool
down, then extract (g. 18) by pressing the release button
(C7). Hold the spout with one hand and with the other, turn
the hot water/steam spout and pull it downwards (g. 26).
3. Also remove the steam connection nozzle by pulling it
downwards (g. 27).
4. Check the hole in the connection nozzle is not blocked. If
necessary, clean using a toothpick.
5. Wash all parts of the spout thoroughly with a sponge and
warm water.
6. Insert the connection nozzle, then the cappuccino maker
on the nozzle by pushing it upwards and turning it clock-
wise until it is attached.
14. MAKING HOT CHOCOLATE
Select CHOCOLATE from the homepage and proceed as follows:
1. "SELECT CUPS NUMBER AND DENSITY (STEP 1 OF 5)":
press the selection arrows to choose whether to pre-
pare 1 cup ( ) or 2 cups ( ) and
the required density (min= ; max =
),
then press " " to conrm
the selection and move on
to the next step (or press
"
BACK
" to go back to the previous screen);
2. "ADD CHOCO STIRRER IN CARAFE (STEP 2 OF 5)": lift the ca-
rafe lid (E1) (g. 28), pull the release slide (E6) and extract
the carafe funnel (E2) (g. 28). Make sure the steam spout
(E3) and choco stirrer (E4) are in place (g. 29), then insert
the assembled funnel in the carafe (g. 30);
3. Press " " to move on to the next step
(or press
"
BACK
" to go back to the previous screen);
4. "POUR MILK OR WATER TO DESIRED LEVEL (STEP 3 OF 5)"
(g. 31): to make one cup of chocolate, pour milk at re-
frigerator temperature (or cold water) into the funnel up
to the level. To make two cups or one mug of choc-
olate, pour the milk (or water) into the funnel up to the
level. When you have added the milk (or
water), press “
(or press
BACK
to go back
to the previous screen);
5. "ADD CHOCOLATE POWDER THROUGH THE FUNNEL (STEP
4 OF 5)" (g. 32): to make one cup of chocolate, add two
measures (C2) (25 g) of hot chocolate powder. To make two
cups or one mug of hot chocolate, add four measures of hot
chocolate powder. When you have added the hot chocolate
powder, press “
(or press
BACK
to go back
to the previous screen);
Important!
Make sure the hole in the funnel shown in g. 33 is clean.
Please note!
The milk must be poured into the funnel when the steam
spout and stirrer are already in place. Do not exceed the
level marked on the carafe. Increase or
reduce the quantity of hot chocolate powder according to
taste.
To use water instead of milk, follow the instructions for
milk.
To prepare hot chocolate correctly, rst pour the milk (or
water) into the funnel, then add the hot chocolate or cocoa
powder.
34
35
6. "CLOSE LID AND INSERT CARAFE, PRESS OK TO START": Close
the lid (g. 34) and attach the carafe to the connection noz-
zle, pushing it as far as it will go (A9, g. 35). The machine
emits a beep (if the beep function is enabled);
7. Press “ to start the function; the appliance starts
mixing the hot chocolate powder then delivers steam to
heat it;
Please note!
If the hot chocolate powder used does not contain thicken-
er, adjusting the density will have no eect.
To stop making chocolate, press " ".
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi Prima Donna Elite ECAM 650.85 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi Prima Donna Elite ECAM 650.85 in the language / languages: English as an attachment in your email.

The manual is 18,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi Prima Donna Elite ECAM 650.85

DeLonghi Prima Donna Elite ECAM 650.85 User Manual - Dutch - 26 pages

DeLonghi Prima Donna Elite ECAM 650.85 User Manual - French - 32 pages

DeLonghi Prima Donna Elite ECAM 650.85 User Manual - Italian - 32 pages

DeLonghi Prima Donna Elite ECAM 650.85 User Manual - Spanish - 32 pages

DeLonghi Prima Donna Elite ECAM 650.85 Additional guide - All languages - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info