686495
5
Zoom out
Zoom in
Previous page
1/31
Next page
10
the surfaces of the appliance and the side and rear walls
and at least 15 cm above the coee maker.
Water penetrating the appliance could cause damage.
Do not place the appliance near taps or sinks.
The appliance could be damaged if the water it contains
freezes. Do not install the appliance in a room where the
temperature could drop below freezing point.
Arrange the power cord in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces (e.g.
electric hot plates).
5.3 Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
Connect the appliance to a correctly installed and eciently
earthed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
electrician.
5.4 Setting up the appliance
Please note!
Coee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coee
in the mill. The machine is, however, guaranteed to be new.
You should customise water hardness as soon as possible
following the instructions in section “20. Setting water
hardness”.
1. Plug the power cord (C8) connector into the socket (A20) at
the back of the appliance and connect the appliance to the
mains electricity supply (g. 1). Make sure the main switch
(A21) at the back of the appliance is pressed (g. 2);
2. "SELECT LANGUAGE": press (B10) or
(B8)
until the
ag corresponding to the required language appears on
the display (B), then press the ag;
Follow the instructions indicated on the appliance display:
3. "FILL TANK WITH FRESH WATER": remove the water tank
(A16) (g. 3), open the lid (A15) (g. 4), ll to the MAX line
(marked on the inside of the tank) with fresh water (g. 5),
close the lid and put the tank back in the appliance (g. 6);
4. "INSERT WATER SPOUT": Check that the hot water/steam
spout (C6) is inserted on the connection nozzle (A9) (g.
7) and place a container holding a minimum of 100 ml un-
derneath (g. 8);
5. "WATER CIRCUIT EMPTY PRESS OK TO START FILLING PRO-
CESS" appears on the display;
6. Press " " to conrm. The appliance delivers water
from the spout (g. 8) then goes o automatically.
The coee machine is now ready for normal use.
Please note!
The rst time you use the appliance, you need to make 4-5
cappuccinos before it starts to give satisfactory results.
The rst time you use the machine, the water circuit is
empty and the appliance could be very noisy. The noise
becomes less as the circuit lls.
When making the rst 5-6 cappuccinos, it is normal to hear
the noise of boiling water. After this, the noise becomes
less.
To improve the performance of your appliance, we recom-
mend installing a water softener lter (C4) as described
in section “21. Water softener lter”. If your model is not
provided with a lter, you can request one from De'Longhi
Customer Services.
6. TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch
(A21) is pressed (g. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
(A8) and is collected in the drip tray (A14) underneath. Avoid
contact with splashes of water.
To turn the appliance on, press the button (A7-g.
9). The message "HEATING UP UNDERWAY PLEASE WAIT"
appears on the display.
When heating is complete, the message changes to: "RINS
ING UNDERWAY, HOT WATER FROM SPOUTS". As well as
heating the boiler, this also heats the internal circuits by
circulating hot water.
The appliance is at temperature when the main screen (home-
page) appears.
7. TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts
(A8). Avoid contact with splashes of water.
To turn the appliance o, press the button (A7-g.
9).
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi Prima Donna Elite ECAM 650.85 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi Prima Donna Elite ECAM 650.85 in the language / languages: English as an attachment in your email.

The manual is 18,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi Prima Donna Elite ECAM 650.85

DeLonghi Prima Donna Elite ECAM 650.85 User Manual - Dutch - 26 pages

DeLonghi Prima Donna Elite ECAM 650.85 User Manual - French - 32 pages

DeLonghi Prima Donna Elite ECAM 650.85 User Manual - Italian - 32 pages

DeLonghi Prima Donna Elite ECAM 650.85 User Manual - Spanish - 32 pages

DeLonghi Prima Donna Elite ECAM 650.85 Additional guide - All languages - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info