ELECTRICAL REQUIREMENTS
5
The flexible mains lead is supplied connected
to a B.S. 1363 fused plug having a fuse of 13
amp capacity.Should this plug not fit the socket
outlets in your home, it should be cut off and
replaced with a suitable plug, following the
procedure outlined below.
Note: Such a plug cannot be used for any other
appliance and should therefore be properly
disposed of, (having removed the fuse) and not
left where children might find it and plug it into
a supply socket - with the obvious consequent
danger.
If the plug is a moulded-on type the fuse cover
must be refitted. If the fuse cover is lost, the plug
must not be used until a replacement cover is
obtained. The colour of the correct replacement
fuse cover is that of the coloured insert in the base
of the fuse recess or elsewhere on the plug.
Always state this colour when ordering a
replacement fuse cover.
N.B. We recommend the use of good quality
plugs and wall sockets that can be switched off
when the machine is not in use.
IMPORTANT: the wires in the mains lead fitted
to this appliance are coloured in accordance
with the following code:
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured green and yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the
earth symbol or coloured green or green
and yellow.
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
When wiring the plug, ensure that all strands
of wire are securely retained in each
terminal. Do not forget to tighten the mains
lead clamp on the plug. If your electricity
supply point has only two pin socket outlets,
or if you are in doubt, consult a qualified
electrician.
Should the mains lead ever require
replacement, it is essential that this operation
be carried out by a qualified electrician and
should only be replaced with a flexible cord
of the same size.
Only 13amp replacement fuses which are ASTA
approved to B.S. 1362 should be fitted.
This appliance conforms to the Norms EN
55014 regarding the suppression of radio
interference.
Before using this appliance ensure that the voltage indicated on the product corresponds with
the main voltage in your home, if you are in any doubt about your supply contact your local
electricity company.
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
WARNING - THIS APPLIANCE MUST BE EARTHED
Green and Yellow to
Earth
Blue to
Neutral
13 amp
Fuse
Brown to
Live
Cord Clamp
