Collection
28
7 CHANGING THE QUANTITY OF COFFEE IN THE CUP
The appliance is factory preset to automatically deliver the following quantities of coffee:
- two short coffees (when the button is pressed);
- long coffee (when the button is pressed);
- two short coffees (when the button is pressed);
- two long coffees (when the button is pressed); .
To change these quantities, proceed as follows:
- press the button corresponding to the quantity you want to change ( or or or ) for
at least 8 seconds then release until the message "PROGRAM QUANTITY" is displayed and coffee is delive-
red;
- when the coffee in the cup reaches the required level, press the same button again to memorise the new
amount.
The appliance emits a double “beep“ of confirmation.
The appliance is now re-programmed with the new settings and displays: READY.
8 REGULATING THE COFFEE MILL
The coffee grinder is preset in the factory to prepare coffee correctly and should not require regulating initially.
However, after making the first coffees, if you find that coffee delivery is either too fast or too slow (in drips),
the grinding coarseness regulator can be adjusted (fig. 11).
Turning it 1 click (1 line) towards the number 7 speeds up coffee delivery (without drips).
Turning 1 click towards the number 1 slows down delivery giving a creamier appearance to the coffee.
These adjustments will only be evident after at least 2 cups of coffee have been run off.
The grinding coarseness regulator must only be turned when the coffee mill is on.
Turn one click towards the number 1 to obtain slower delivery and
a creamier appearance (finer ground coffee).
Turn one click towards the number 7 for faster delivery (not a drop
at a time) (coarser ground coffee).
9 PREPARING ESPRESSO COFFEE WITH PRE-GROUND COFFEE (INSTEAD OF BEANS)
• Select the ground coffee function by pressing the /OK button (fig. 16) repeatedly until
READY - PRE-GROUND COFFEE
flashes on the display. This disables the coffee mill function.
• Lift the lid in the centre, place one level measure of ground coffee in the funnel (see fig. 15) and proceed
as described in section 6. NB: NB: You can make one coffee at a time by pressing the or button.
• After using the appliance with pre-ground coffee, to go back to making coffee using beans, deactivate the
ground coffee function by repressing the button to prepare the grinder for operation again.
NOTE 1: Never add the ground coffee when the appliance is off to avoid it from being dispersed inside the
appliance.
NOTE 2: Never add more than one level measure, otherwise either the appliance will
not make the coffee and the ground coffee will be lost inside the appliance, dirtying
it, or the coffee will run off in drips.
