770033
17
Zoom out
Zoom in
Previous page
1/19
Next page
22
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
Turn the milk froth
adjustment dial
The milk container (D) has been inserted with
the froth adjustment dial (D2) in the "CLEAN"
position.
Turn the froth adjustment dial to one of the
milk froth positions.
Descale
ESC to cancel
OK to descale
(45 minutes)
The machine must be descaled. The descaling procedure described in section
"13. Descale" needs to be performed.
Replace lter
ESC to cancel
OK to replace
The water softener lter (C4) is exhausted. Replace the lter or remove it as described in
section "15. Water softener lter".
General alarm The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section "12. Cleaning". If the
message is still displayed after cleaning, con-
tact a customer service centre.
The tubes inside the milk container (D) must
be cleaned.
Turn the froth adjustment dial (D2) to CLEAN
(g. 20)
.
The water softener lter (C4) is exhausted and
must be replaced or removed.
Replace the lter or remove it as described in
section "15. Water softener lter".
The machine must be descaled. The descaling procedure described in section
"13. Descale" needs to be performed.
The appliance may request descaling cycles at
very short intervals. This is normal and due to
the appliance’s advanced control system.
ECO Energy saving is enabled. To disable energy saving, proceed as described
in section "6.4 General" - "Energy saving:"
18. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM POSSIBLE CAUSE REMEDY
The coee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
The internal circuits of the appliance have
cooled down because 2/3 minutes have
elapsed since the last coee was made.
Before making coee, heat the infuser by
performing a rinse cycle (see section "6.1
Rinsing").
A low coee temperature is set. Set a higher coee temperature in the menu
(see section "6.4 General""Set temperature:")
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi ESAM420.40 - Perfecta Evo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi ESAM420.40 - Perfecta Evo in the language / languages: English as an attachment in your email.

The manual is 13.2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi ESAM420.40 - Perfecta Evo

DeLonghi ESAM420.40 - Perfecta Evo User Manual - Dutch - 21 pages

DeLonghi ESAM420.40 - Perfecta Evo User Manual - French - 20 pages

DeLonghi ESAM420.40 - Perfecta Evo User Manual - Italian - 20 pages

DeLonghi ESAM420.40 - Perfecta Evo User Manual - Spanish - 20 pages

DeLonghi ESAM420.40 - Perfecta Evo Additional guide - All languages - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info