GB
33
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from
the mains, then plug in again. Wait for all the lights to go off after the self-diagnosis, then open the door and
replace the infuser.
15.3 CLEANING THE MILK CONTAINER
Proceed as follows:
1. Remove the milk spout (fig. 32) and intake tube.
2. Wash all the components thoroughly with hot water and washing-up liquid.
3. Make sure there are no milk residues inside the
two holes in the lid of the milk container indicated
by the arrows in the figure.
4. Put back the intake tube and milk spout.
16 CHANGING AND SETTING THE MENU PARAMETERS
After pressing the button, when the appliance is ready, you can use the internal menu to modify the fol-
lowing parameters and functions:
• Clock
• Auto-start time.
• Descaling process
• Coffee temperature
• Length of time the appliance remains on
•Water hardness
• Factory default values
•Washing process
16.1 SETTING THE CLOCK
To set the clock, proceed as follows:
1. Press the button (the light over the button comes on) then press the button repeatedly until
the appliance displays:
CLOCK 00:00
2. Press the button to set the clock. (If you hold the button down, the time is changed
rapidly).
3. Press the button to confirm the value;
4. Press the button to exit programming mode or to change other parameters.
16.2 SETTING AUTO-START TIME
This enables the time the appliance will come on automatically and be ready for use to be programmed.
1. Make sure the clock on the appliance is set as described above.
2. Press the button then press the button repeatedly until the appliance displays:
START TIME 07:30
