11 CHANGING THE QUANTITY OF HOT WATER
The appliance is factory preset to automatically deliver 250 ml of hot water.
To change these quantities, proceed as follows:
1. Attach the water spout (fig. 4).
2. Position a container under the spout (fig. 3).
3. Press the button for at least 8 seconds then release. The appliance displays:
HOT WATER PROGRAM QUANTITY
and hot water is run off from the water spout.
4. When the hot water in the cup reaches the required level, press the button to memorise the new
amount. (You should not run off hot water for more than two minutes at a time).
12 PREPARING CAPPUCCINOS (FROTHED MILK AND COFFEE)
1. Select the taste of the coffee you want to use to make the cappuccino by pressing the button
2. Remove the lid of the milk container.
3. Fill the container with about 100 grams of milk for each cappuccino to be prepared (fig. 19). Never
exceed the MAX level (corresponding to about 750 ml) marked on the container. You are recommen-
ded to use skimmed or semi-skimmed milk at refrigerator temperature (about 5° C).
4. Make sure the intake tube is well inserted into the rubber washer (fig. 20), then replace the milk contai-
ner lid.
5. Remove the hot water spout (fig 21) and attach the milk container to the nozzle, making sure the arrow on the
container lid is lined up with the arrow on the control panel of the appliance (fig. 22).
6. Position the milk tube as shown in fig. 23 and then place a sufficiently large cup under the coffee and
milk spouts (fig. 23).
7. Press the button (fig. 24). The appliance displays:
CAPPUCCINO
and after a few seconds, the frothed milk is run off from the milk spout into the cup below. (Run off stops
automatically).
8. The appliance then grinds the beans, delivers the coffee and displays the "ready" message again.
9. The cappuccino is ready. Sweeten to taste and, if desired, sprinkle the froth with a little cocoa powder.
NOTE 1: While preparing the cappuccino, frothed milk or coffee run off can be interrupted by pressing but-
ton .
NOTE 2: If you run out of milk while delivering frothed milk, remove the container and refill it. Then put it
back in place and press the button to request a cappuccino again.
NOTE 3: To ensure the milk frother is absolutely clean and hygienic, after making cappuccinos, clean the
channels inside the milk container lid:
•Place a recipient under the milk spout;
•Press the button on the milk container lid down and hold down for at least 8 seconds (fig. 25).
The appliance displays:
CLEANING
After cleaning is complete, remove the milk container and place in the refrigerator. You should not leave
the milk outside the refrigerator for more than 15 minutes.
NOTE 4: To change the quantity of coffee or frothed milk delivered automatically into the cup, follow the
instructions in section 14.
30
