800465
6
Zoom out
Zoom in
Previous page
1/20
Next page
119
6. TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch
(A20) is pressed (g. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
(A7) and is collected in the drip tray (A12) underneath. Avoid
contact with splashes of water.
To turn the appliance on, press the button (B1-g.
8). The message “Heating up, Please wait” appears on the
display (B13).
When heating is complete, the message changes to “RINSING”.
As well as heating the boiler, this also heats the internal circuits
by circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coee appears.
7. TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts
(A7). Avoid contact with splashes of water.
To turn the appliance o, press the button (B1- g.
8).
The message “Turning o Please wait” appears on the
display (B13), then, if necessary, the appliance performs a
rinse cycle and goes o (standby).
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
rst turn the appliance o by pressing the button;
release the main switch (A20) at the back of the appliance
(g. 2).
Important!
Never press the main switch while the appliance is on.
8. MENU SETTINGS
8.1 Rinsing
Use this function to deliver hot water from the coee spout (A7)
and from the hot water/steam spout (C6), if inserted, to clean
and heat the appliances internal circuit.
Place a container with a minimum capacity of 100 ml under the
hot water/steam spout (g. 7).
To enable the function, proceed as follows:
1. Press the MENU/ESC button (B14) to enter the menu;
2. Press < (B4) or > (B8) (g. 9) until “Rinsing” appears on
the display (B13);
3. Press the OK button (B12-g. 10): the message “Conrm?”
is displayed;
Danger of burns!
Do not leave the appliance unattended while hot water is being
delivered.
4. Press the OK button. “RINSING Please wait” is displayed;
5. After a few seconds, hot water is delivered rst from the
coee spouts, then from the hot water/steam spout (if in-
serted) to heat the appliances internal circuit. “RINSING” is
displayed, together with a progress bar which lls gradual-
ly as preparation proceeds;
6. To stop the process press any button or wait for delivery of
water to stop automatically.
Please note!
If the appliance is not used for more than 3-4 days, when
switched on again, we strongly recommend performing
2/3 rinses before use;
After cleaning, it is normal for the grounds container (A10)
to contain water.
8.2 Descaling
For instructions on descaling, see section “13. Descaling”.
8.3 Install lter
For instructions on how to install the lter, see section “15.
Water softener lter”.
8.4 Replacing the water softener lter (if
installed)
For instructions on how to replace the lter, see section “15.2
Replacing the lter”.
8.5 Adjust time
To adjust the time on the display (B13), proceed as follows:
1. Press the MENU/ESC button (B14) to enter the menu;
2. Press < (B4) or > (B8) (g. 9) until Adjust time is
displayed;
3. Press the OK button (B12-g. 10): the hours ash on the
display;
4. Press < or > to change the hour;
5. Press the OK button to conrm. The minutes ash;
6. Press < or > to change the minutes;
7. Press the OK button to conrm.
The time is set. Press the MENU/ESC button to exit the menu.
8.6 Auto-start
You can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coee immediately.
Please note!
To enable this function, the time must already be set correctly.
To enable auto-start, proceed as follows:
1. Press the MENU/ESC button (B14) to enter the menu;
2. Press < (B4) or > (B8) (g. 9) until Auto-start” appears on
the display (B13);
3. Press the OK button (B12- g. 10). “Enable?” is displayed;
4. Press the OK button to conrm;
5. Press < or > to choose the hour;
6. Press the OK button to conrm;
7. Press < or > to change the minutes;
8. Press the OK button to conrm;
9. Press the MENU/ESC button to exit the menu.
Once the time has been conrmed, activation of auto-start is
indicated by the symbol displayed alongside the time.
To disable the function:
1. Select auto-start from the menu;
2. Press the OK button. “Disable?” is displayed;
3. Press the OK button to conrm.
The symbol is no longer displayed.
8.7 Auto-o (standby)
Auto-o can be set so that the appliance goes o after 15 or 30
minutes, or 1, 2 or 3 hours.
To programme Auto-o, proceed as follows:
1. Press the MENU/ESC button (B14) to enter the menu;
2. Press < (B4) or > (B8) (g. 9) until Auto-start appears on
the display (B13);
3. Press the OK button (B12- g. 10);
4. Press < or > until the required operating time (15 or 30
minutes, or 1, 2 or 3 hours) is displayed;
5. Press the OK button to conrm;
6. Press the MENU/ESC button to exit the menu.
Auto-o is now programmed.
8.8 Cup warmer
This function enables the cup warmer to be enabled or disabled.
Proceed as follows:
1. Press the MENU/ESC button (B14) to enter the menu;
2. Press < (B4) or > (B8) (g. 9) until “Cup warmer” appears
on the display (B13);
3. Press the OK button (B12- g. 10). “Enable?” or “Disable?”
is displayed;
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi ECAM45.760 Eletta Cappuccino at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi ECAM45.760 Eletta Cappuccino in the language / languages: English as an attachment in your email.

The manual is 2.95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi ECAM45.760 Eletta Cappuccino

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - German - 27 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Dutch - 20 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Danish - 20 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - French - 21 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Italian - 26 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Polish - 20 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Portuguese - 22 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Swedish - 19 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Turkish - 19 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Spanish - 22 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Norwegian - 19 pages

DeLonghi ECAM45.760 Eletta Cappuccino User Manual - Finnish - 19 pages

DeLonghi ECAM45.760 Eletta Cappuccino Additional guide - All languages - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info