562609
10
Zoom out
Zoom in
Previous page
1/25
Next page
9
Installing the appliance
Important!
When you install the appliance, you should respect the fol-
lowing safety warnings:
The appliance gives o heat. After positioning the applian-
ce on the worktop, leave a space of at least 3 cm between
the surfaces of the appliance and the side and rear walls
and at least 15 cm above the coee machine.
Water penetrating the appliance could cause damage. Do
not place the appliance near taps or sinks.
The appliance could be damaged if the water it contains
freezes. Do not install the appliance in a room where the
temperature could drop below freezing point.
Arrange the power cable in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces (e.g.
electric hot plates).
Setting up the appliance
Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
Connect the appliance to an eciently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Using the appliance for the rst time
Please note!
Coee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
You should customise water hardness as soon as possible
following the Instruction for use in the section “Setting
water hardness (page 19).
1. Plug the power cable into the socket on the back of the
appliance and connect the appliance to the mains power
supply (g. 1) and make sure that the main switch, located
on the side of the appliance, is pressed (g. 2).
Select the desired language by scrolling forwards or backwards
using the CAFFELATTE or button, or alternatively waiting
for the language options to scroll automatically on the display
(about every 3 seconds):
2. When “English” appears, hold the button (g. 3) for a
few seconds until “English set” is displayed.
Follow the instructions indicated on the appliance display:
3. “FILL TANK”: extract the water tank (g. 4), open the lid
(g. 5), ll to the MAX line with fresh water (g. 6); close
the lid again and then replace the tank.
4. INSERT WATER SPOUT”: Check that the hot water spout is
inserted on the connection nozzle and place a container hol-
ding a minimum of 100 ml underneath (g. 7).
5. “Insert Water Spout and Press Ok” is displayed;
6. Press the button to conrm (g. 3). The appliance deli-
vers water from the spout then goes o automatically.
The coee machine is now ready for normal use.
Please note!
When using the appliance for the rst time, you need to
make 4-5 cups of coee or 4-5 cappuccinos before it starts
to give satisfactory results.
When making the rst 5-6 cappuccinos, it is normal to hear
the noise of boiling water. After this, the noise becomes
less.
To enjoy your coee even more and improve the perfor-
mance of your appliance, we recommend installing a water
softener lter as described in the section “ WATER SOFTE-
NER FILTER “ (page 19). If your model is not provided
with a lter, you can request one from De’Longhi Customer
Services.
TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch is
pressed (g. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
To turn the appliance on, press the button (g. 8).
The message “Heating up, Please wait” is displayed.
After heating, the message “Rinsing” is displayed. As well as he-
ating the boiler, the appliance also heats the internal circuits by
circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coee appears.
TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi ECAM 45.366 - ELETTA CAPPUCCINO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi ECAM 45.366 - ELETTA CAPPUCCINO in the language / languages: English as an attachment in your email.

The manual is 2.8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi ECAM 45.366 - ELETTA CAPPUCCINO

DeLonghi ECAM 45.366 - ELETTA CAPPUCCINO User Manual - German - 27 pages

DeLonghi ECAM 45.366 - ELETTA CAPPUCCINO User Manual - Dutch - 17 pages

DeLonghi ECAM 45.366 - ELETTA CAPPUCCINO User Manual - French - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info