456905
14
Zoom out
Zoom in
Previous page
1/14
Next page
18
19
LIGHT POSSIBLE CAUSE REMEDY
LAMPEGGIANTE
The infuser has not been replaced after
cleaning.
Insert the infuser as described in the section “Cleaning
the infuser”.
The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described
in the section “Cleaning and maintenance”.
If the message is still displayed after cleaning, contact a
customer services.
TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM POSSIBLE CAUSE REMEDY
The coee is not hot
The cups were not preheated. Warm the cups by rinsing them with hot water (Please note
you can use the hot water or rinse function).
The infuser has cooled down because 2/3 minutes have
elapsed since the last coee was made.
Before making the coee, warm the infuser by pressing the
rinse button .
The coee is thin or not
creamy enough.
The coee is ground too coarsely. Turn the grinding adjustment dial one click anticlockwise
while the coee mill is in operation (g. 8).
Continue one click at a time until coee delivery is
satisfactory. The eect is only visible after delivering two
coees (see the section: Adjusting the coee mill” on
page 13).
The coee is unsuitable. Use pre-ground coee for espresso coee makers.
The coee is delivered too
slowly or a drop at a time
The coee is ground too nely. Turn the grinding adjustment dial one click clockwise while
the coee mill is in operation (g. 10). Continue one click at
a time until coee delivery is satisfactory. The eect is only
visible after delivering 2 coees (see the section: Adjusting
the coee mill” on page 13).
Coee does not come out of
one of the spouts
The spouts are blocked. Clean the spouts with a toothpick.
The frothed milk has large
bubbles
The milk is not cold enough or is not semi-skimmed. You should ideally use skimmed or semi-skimmed milk at
refrigerator temperature (about 5°C).
If the result is still disappointing, try another brand of milk.
The milk is not frothed
Cappuccino maker dirty. Clean as described in the section "Cleaning the cappuccino
maker after use" on page 13.
Steam delivery stops during
use
A safety device stops steam delivery after 3 minutes. Wait a few minutes, then activate the steam function
again.
The appliance does not
come on
It is not plugged into the mains socket. Plug into the mains socket.
The main switch (A8) is not turned on. Place the main switch in the I position (g. 1).
EXPLANATION OF LIGHTS
LIGHT POSSIBLE CAUSE REMEDY
FLASHING
Insucientwaterinthetank. Fill the tank with water and insert it correctly, pushing it as
far as it will go until it clicks into place.
The tank is not correctly in place. Insert the tank correctly and press as far as it will go.
FLASHING
The grounds container (A13) is full. Empty the grounds container and drip tray, clean and
replace. Important: when removing the drip tray, the
grounds container MUST be emptied, even if it contains
few grounds. If this is not done, when you make the next
coees, the grounds container may ll up more than
expected and clog the machine.
After cleaning, the grounds container has
not been replaced.
Remove the drip tray and insert the grounds container.
FLASHING
The grinding is too ne and the coee is
delivered too slowly or not at all.
Repeat coee delivery and turn the grinding adjustment
dial (g. 10) one click clockwise towards “7” while the
coee mill is in operation. If after making at least 2 coees
delivery is still too slow, repeat the correction procedure,
turning the grinding adjustment dial another click until
delivery is correct (see the section: Adjusting the coee mill
on page 12). If the problem persists, turn the steam dial to
the I position and deliver water from the cappuccino maker.
FLASHING
The "pre-ground coee" function has been
selected without placing any pre-ground
coee in the funnel.
Place pre-ground coee in the funnel or deselect the
"pre-ground" function.
FLASHING
The machine must be descaled. The descaling procedure described in the section
“Descaling” needs to be performed as soon as possible.
FLASHING
Too much coee has been used. Select a milder taste or reduce the quantity of pre-ground
coee then make the coee again.
FLASHING
The coee beans have run out. Fill the beans container
The pre-ground coee funnel is clogged. Empty the funnel with the help of a knife as described in
the section "Cleaning the pre-ground coee funnel".
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi ECAM 22.110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi ECAM 22.110 in the language / languages: English as an attachment in your email.

The manual is 3,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi ECAM 22.110

DeLonghi ECAM 22.110 User Manual - English - 21 pages

DeLonghi ECAM 22.110 User Manual - German - 14 pages

DeLonghi ECAM 22.110 User Manual - German, Dutch, Danish - 21 pages

DeLonghi ECAM 22.110 User Manual - French - 20 pages

DeLonghi ECAM 22.110 User Manual - French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Spanish, Norwegian, Finnish - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info