770075
2
Zoom out
Zoom in
Previous page
1/4
Next page
11
Push the tank into place carefully. If it knocks against the
walls or is incorrectly inserted, the appliance may not
function. (The tank full light ashes.) Remove the tank
then replace carefully in position.
3.2 Continuous external draining
If the appliance is to be operated for long periods but you are
unable to empty the tank regularly, you are recommended to use
continuous draining. Proceed as follows:
1. Remove the rubber bung from the outlet tube (Fig. 4).
2. Fasten the rubber hose to the spout (g. 5).
3. Make sure the hose is no higher than the spout (g.
6), otherwise the water will ow into the tank of the
appliance. Make sure there are no kinks in the hose.
Please note:
Keep the rubber bung. You will need it to plug the hose or
close the outlet tube if you revert to draining into the tank.
4. MODE SELECTION
1. Plug the appliance into a mains socket:
2. Touch the ON/STAND-BY button
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
(B1) for 2/3 seconds
to turn the appliance on: the appliance will operate in the
previously-set mode and the deector (A2) opens in a
preset position.
To turn the appliance o, touch the ON/STAND-BY button again.
Please note:
If
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
(C7) appears on the display, it is necessary to empty or
correctly position the tank (A7) (see paragraph “3.1 Draining
into the tank”).
Place the dehumidier at least than 30 cm from the
laundry to be dried. NEVER place the dehumidier under
the laundry to be dried.
Before unplugging from the mains, wait for the fan to stop.
The fan remains in operation for about two minutes after
the appliance is turned o to allow the heating element to
cool down.
When started up, or when power is restored, the appliance
operates in the mode selected before it shut down.
Important: Before unplugging from the mains, wait for
the fan to stop. The fan remains in operation for about
two minutes after the appliance is turned o to allow
the heating element to cool down.
4.1 Dehumidifying mode
Touch the MODE button (B2) to select modes, the deector
opens and the appliance comes in AUTO mode (g. 7).
The display will show:
AUTO: To maintain a comfortable level of humidity. The
unit controls room humidity in 45~50% RH. Fan speed is
automatically controlled (high or low).
(Auto will light on by default at the rst run).
DRY
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
: Super dry mode to dry laundry. Use this
programme to dry garments rapidly and or during the
winter.
MIN
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
: for silent operation. The unit automatically
dehumidies in low fan speed and low noise.
MAX
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
: to dehumidify rapidly. The unit runs
high fan and controls room humidity in 35~40% RH.
ECO: Eco mode to dry laundry (high fan, low heater).
Use this programme during the summer. The appliance
operates automatically with low energy consumption.
Please note:
The humidity display shows relative humidity status
of room air. Due to condition of machine position, air
circulation and sensor accuracy, the values are for reference
only that may have variations around ±10%RH.
4.2 Ioniser mode
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
1. Before using this function, make sure the appliance is on.
Touch the ioniser button (B4). The
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
icon (C4) comes on
(Fig.8) and the appliance emits negative ions from the air
outlet grille (A9).
2. Touch the ioniser button again to interrupt negative ion
emission. (The symbol on display goes o ).
A large quantity of negative ions are produced, quantitatively
similar to those present in environments such as forests or
waterfalls.
4.3 Delayed shutdown timer
1. Before using this function, make sure the appliance is on.
2. Each time the Timer button (B5) is touched, the number of
hours the appliance operates changes and the
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
will be
displayed (Fig.10):
1 h - 2 h - 3 h ..... 12 h - continuous (no showing).
When the timer is set, the remaining hours will show. Even if
the tank full icon is ashing and the unit stops, the counting
continues. After emptying and repositioning the tank, the
appliance continues to operate for the time left (may just a few
time left, in this case, you may want to reset the timer.)
4.4 LCD dimmer
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
Touch the LCD dimmer button (B3) to show the current
setting (Fig. 9) and touch again to set the backlight, on the
display appears:
H (full light) - L5 - L4 - L3 - L2 - L1 - L0 (no backlight) (C3).
After setting (or without touching the key for 5 seconds), the
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
icon (C9) will be displayed showing if the dimmer setting
is among L0 and L5 (and disappears when the setting is H), and
the display will show the timer if it has been set.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi DNS80 AriaDry Light at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi DNS80 AriaDry Light in the language / languages: English as an attachment in your email.

The manual is 0.98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi DNS80 AriaDry Light

DeLonghi DNS80 AriaDry Light User Manual - German - 4 pages

DeLonghi DNS80 AriaDry Light User Manual - Dutch - 4 pages

DeLonghi DNS80 AriaDry Light User Manual - French - 4 pages

DeLonghi DNS80 AriaDry Light Additional guide - All languages - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info