555820
5
Zoom out
Zoom in
Previous page
1/76
Next page
5
1. Set up the pump on a  rm and level surface.
2. Fit the suction pipe so it is ready for use.
3. Fill the pump with water through the delivery
pipe connection.
4. Connect the delivery pipe so it is ready for
use. During the priming operation you have to
fully open all the shut-off mechanisms (spray
nozzles, valves) etc. in the delivery line so that
the air in the suction line can escape freely.
5. Make the connections to the electric supply.
6. Turn on the ON/OFF switch (the pilot lamp on
the switch lights up).
7. The initial priming operation can take approx.
0.5 to 5 minutes, depending on the suction
height and amount of air in the suction pipe. If
the priming takes a long time, you will need to
top up again with water.
8. If the water management system is removed
after being used it is essential to  ll it up again
with water when it is reconnected and re-
started.
11. Maintenance instructions
• The pump is basically maintenance free. To
ensure a long service life, however, we recommend
regular checks and care.
Warning!
Before every servicing, switch off the pump and
remove the plug from the socket.
• If the pump is not going to be used for a long
time or has to be removed for the winter months,
rinse it out with water, empty it completely and
allow it to dry.
• If there is a risk of frost, the pump must be
emptied completely.
After long stoppages, make sure the rotor turns
correctly by brie y switching the pump on and off.
• If the pump becomes blocked, connect the
pressure line to the water line and remove the
intake hose. Open the water line. Switch on the
pump several times for approx. 2 seconds. Most
blockages can be removed in this way.
12. Replacing the mains cable
Warning! Disconnect the pump from the mains!
If the mains cable is defective, it must be
replaced by an electrician.
GB
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Defort DGP-600N at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Defort DGP-600N in the language / languages: All languages as an attachment in your email.

The manual is 8,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info