Manual De Dietrich INISOL - UNO-1 300 (page 10 of 20) (English)

608091

Zoom out

Zoom in

1/20

UNO/2 200, 300, 400, 500 - UNO/1 200, 300, 400, 500 06/02/12 - 300024525-001-B

5 Diemasol A solar regulator

5.1 General description of how the unit operates

In automatic mode, the Diemasol A regulator operates in accordance

with the following principles:

` The sun's rays heat the transfer fluid in the collector. For the

regulation process to be triggered, a minimum temperature of

30 °C is required in the collector and there must be a

temperature difference of 10 K by comparison with the tank.

` During the AUTO-calibration stage which follows (tu parameter

setting tu, factory setting 1 minute) the PUMPE (relay) operates

to its full extent (100%).

` Subsequently, the solar pump regime is calculated dynamically

depending on a difference between the reference temperature

(parameter DT, factory setting 20 K) and the calorifier

temperature.

` Depending on the heat available, the system heats up the solar

tank and cuts off when the tank storage temperature is reached

(adjustment parameter SX, factory setting: 60 °C).

` When the temperature in the collectors reaches the maximum

value (adjustment parameter CX, factory setting 100°C), the

solar pump is triggered to cool the collectors. The pump

continues to operate until the temperature in the collectors is

lower than 5 K at parameter CX and/or the maximum storage

temperature (80°C) is reached in the hot water storage tank.

Regulation goes into cooling mode if the preparer tank

temperature is exceeded. As soon as the temperature in the

collectors drops below the temperature in the calorifier, the

calorifier is cooled down to its set temperature. The installation

is thus protected against overheating and repeated stoppages,

allowing thus the prolonged absence of the user even in the

summer period.

5.2 Start-up

%

If the temperature in the solar collectors is higher

than 130°C, the control system operates in safety mode.

Wait until the evening before start-up or cool down (cover)

the solar collectors.

Switch on the device. The regulator starts an initialisation phase

during which the LED flashes red and green. When initialisation is

complete, the regulator changes to automatic mode. The factory

settings for this mode give optimum performance with most

installations.

If special conditions make it necessary to change the settings, the

corresponding adjustment parameters can be reset.

M000392

M000391

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich INISOL - UNO-1 300 in the language / languages: English as an attachment in your email.

The manual is 1,22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of De Dietrich INISOL - UNO-1 300

De Dietrich INISOL - UNO-1 300 User Manual - Dutch - 12 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

De Dietrich INISOL - UNO-1 300 Manual

Product: