607659

De Dietrich HPI EVOLUTION - AWHP-2 MIT-IN-2 iSystem Manual

34
Zoom out
Zoom in
Previous page
1/52
Next page
Code Messages Description Checking / solution
B09 BL.SC.IN.OPEN
The BL inlet on the PCU PCB
terminal block is open. Antifreeze
protection.
The contact connected to the BL inlet is open.
4 Contact the professional who takes care of
maintenance of the appliance.
Parameter error.
4 Contact the professional who takes care of
maintenance of the appliance.
Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B10 BL.GROUP.EXT.
Failure outside unit.
4 Contact the professional who takes care of
maintenance of the appliance.
B11 BL.COM SCU
Communication error with the
SCU PCB.
4 Contact the professional who takes care of
maintenance of the appliance.
B12 BL.WATER MIS.
The water pressure is lower than
0,5 bar
Not enough water in the circuit.
4 Top up the installation with water.
B13 BL.DHW. S.
The DHW tank sensor is
disconnected or short circuited
Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B14 BL.OUTSIDE.S
The outside temperature sensor is
disconnected or short circuited.
Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B17 BL.BAD PSU
The parameters saved on the
PCU PCB are impaired.
Parameter error on the PCU PCB.
4 Contact the professional who takes care of
maintenance of the appliance.
B18 BL.BAD PSU
The PSU PCB is not recognised Wrong PSU PCB for this heat pump.
4 Contact the professional who takes care of
maintenance of the appliance.
B19 BL.NO CONFIG
The inside module has not been
configured.
The PSU PCB has been changed.
4 Contact the professional who takes care of
maintenance of the appliance.
B39 BL.FLOW
Low flow rate.
4 Contact the professional who takes care of
maintenance of the appliance.
B40 BL.FLOW.STOP
Flow rate fault.
4 Contact the professional who takes care of
maintenance of the appliance.
B41 BL.COM.CPT.kWh
Communication error with the
energy meter option PCB.
Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B50 BL.S.DEP.CPT.kWh
Energy meter flow sensor error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B51 BL.S.RET.CPT.kWh
Energy meter return sensor error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B52 BL.CPT.kWh.ELEC1
Electical meter ELEC 1 error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B53 BL.CPT.kWh.ELEC2
Electical meter ELEC 2 error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B54 BL.CPT.kWh.THERM
Thermal meter error. Bad connection.
4 Contact the professional who takes care of
maintenance of the appliance.
B55 BL.FLOW
Low flow rate.
4 Contact the professional who takes care of
maintenance of the appliance.
6. Troubleshooting AWHP-2 MIT-IN-2 iSystem
33
10/06/2015 - 7629848–001–02
… 34 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich HPI EVOLUTION - AWHP-2 MIT-IN-2 iSystem at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich HPI EVOLUTION - AWHP-2 MIT-IN-2 iSystem in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of De Dietrich HPI EVOLUTION - AWHP-2 MIT-IN-2 iSystem

De Dietrich HPI EVOLUTION - AWHP-2 MIT-IN-2 iSystem User Manual - English - 52 pages

De Dietrich HPI EVOLUTION - AWHP-2 MIT-IN-2 iSystem User Manual - Dutch - 52 pages

De Dietrich HPI EVOLUTION - AWHP-2 MIT-IN-2 iSystem User Manual - French - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info