609084
64
Zoom out
Zoom in
Previous page
1/84
Next page
64
GT 530ADDRA 001 v1.0 06/2010
S2NA or S3NA
Panel Application Wiring
Full Modulating Operation
Factory wiring
Field wiring (By Others)
WARNING
FAILURE TO FOLLOWING THESE PROCEDURES OR WARNING
COULD RESULT IN PROPERTY DAMAGE.
PERSONAL INJURY INCLUDING DEATH MAY RESULT IN
WIRING MISTAKES.
Wiring must be in strict compliance with CSA C22.2 and NEC/
NFPA 70. All wiring shown supplied and wired by othersThis
equipment must be earth bonded or grounded.All wiring (eld
or replacement) must be min 18AWG type CSA TEW/ UL 1015
rated 105°C or an approved equivalent.
All wiring and panels must be shielded from spray or ingestion
of water.Any portion of the control which has been subject
to spray or ingestion of water, the entire control must be
replaced.It is the responsibility of the installer/owner to
verify the controls are functioning correctly and are adjusted
correctly.Suitable wire protection and strain relief’s are
required (upstream & downstream) of the control panel.
Line voltage wiring and low voltage sensor wiring must use
separate wire conduits.
LABEL ALL WIRES PRIOR TO DISCONNECTING THEM FOR
SERVICE.
1 2 3
4
5
6
7
9
10 11
8 13 14
12
1615
18
19
17 21
20 23
24
22 2625
28
2927 3130
33
3432 3635 38
37
120/60/1
Main Power Supply
Tekmar®
thermostat TT
connection
CS – Safety
Contact 120v
1
st
Stage
2
nd
stage
N
Gnd
Heating
Pump
L
N Lc
Lc
Limit Circuit
Burner Connections
L N
Burner main
power
DHW
Pump
120/24v
Transformer
Tekmar®
DBC-001 & 002 Control Connections
Tekmar®
DBC-001 & 002 Sensor Connections
Optional wiring for Tekmar® DBC-001 & 002 controller
Burner Connections
Fuse
15A Max.
Service
Switch
LWCO
Optional
Limit
Optional
(No) Contact
Optional Safety
Interlock
Optional Safety
Interlock
Main Power 120/60/1
B
R
W
T991A or 0-10v or
4-20mA Mod.
signal
Factory wiring
Field wiring
(By Others)
64


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich GT530AE Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich GT530AE Series in the language / languages: English as an attachment in your email.

The manual is 13,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info