481718
24
Zoom out
Zoom in
Previous page
1/76
Next page
23
De Dietrich Gas 310/610 ECO
7.3.6 Continued
CLV system application (Different Pressure Zones)
This venting system uses two separate vents that terminate a
different points of the building (2 different pressure zones), a
vent for combustion air and another for the flue gases. All
combustion air is from the outdoor source. The vent terminal
shall discharge flue gases away from the building structure so
that the flue gases do not cause damage to the building. The
vent terminal locations follow local and national codes
requirements. [See section 7.3.9]
7.3.7 Sidewall vented application with or without direct vent (sealed combustion air):
Caution Warning:
Flue gas condensation is very aggressive and corrosive
which could lead to failure of the venting system or
drains, consult local and national codes regarding flue
gas condensation disposal. The P-trap assembly must
be properly filled with water to avoid escape of the flue
gas emissions. The flue gas condensation may require
neutralization prior to entering the drain.
Warning:
An improperly sealed venting system could result in
carbon monoxide poisoning; ensure adequate support
and fastening of the system. Ensure venting can safely
exhaust all flue gases to the outside in a safe and
effective manner. Do not puncture or drill holes in any
portion of the venting, the boiler is equipped with a
pressure and emission test port. All venting must be
arranged to avoid and prevent the accumulation of flue
gas condensation.
CLV vent systems venting length chart
Gas 310/610
Model
Vent ø
Vent Length
[Min]
Vent
Length
[Max]
90° Elbow =
Length
45° Elbow =
Length
inch
mm
Ft.
m
Ft.
m
Ft.
m
Ft.
mm
310-5
10 250 5 1.5 180 54 12 3.5 6.5 2
310/610-6
310/610-7
310/610-8
310/610-9
Table 04[c] - venting length chart.
Table also applies to Gas 610 models.
L = Max
Gas310 Eco Boiler
[Left hand version shown]
CLV (different pressure zones) application with
Direct vent (Sealed Combustion Air) supply
L = Max
Fig. 8
Gas310 Eco Boiler
[Left hand version shown]
Sidewall vented application with or without
Direct vent (Sealed Combustion Air) supply
L = Max
Fig. 9
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich Gas 610 ECO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich Gas 610 ECO in the language / languages: English as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info