481718

De Dietrich Gas 610 ECO Manual

10
Zoom out
Zoom in
Previous page
1/76
Next page
9
De Dietrich Gas 310/610 ECO
e. Flue gas damper (optional for Gas 310
boiler, standard for Gas 610 boiler)
3.2 OPERATING PRINCIPLE
Combustion air is drawn into the inlet connection from the plant room (room ventilated version) or from outside via
the eccentric flue system (room sealed) by an air supply fan.
On the inlet side of the fan is a specially designed chamber (venturi unit) which takes gas from the multi-block and
mixes it in the correct proportions with the incoming air. This mixing system ensures that the correct gas/air ratio
is delivered to the pre-mix burner at all times.
Depending on demand (under the dictates of flow/return sensor and other external/internal control inputs) the
‘abc®’ system determines the required boiler output. The ‘abc®
’
control then varies the speed of the air supply
fan which alters the volume of air being drawn into the venturi, this change in volume is measured using air
pressure differential which directly controls the volume of gas also being delivered to the venturi. The resultant
controlled mixture is delivered to the premix burner.
This mixture is initially ignited by the combined ignition/ionization probe which monitors the state of the flame.
Should the flame be unstable or not ignite within the pre-set safety time cycle the controls will (after 5 attempts)
shut the boiler down requiring manual intervention to reset the boiler. The digital display will indicate a flashing
fault code confirming the reason for the failure.
The products of combustion in the form of hot flue gases are forced through the heat exchanger transferring their
heat to the system water, (the flue gas temperature is reduced to approximately 9-14°
F [5-8°
C] above the
temperature of the system return water) then discharged via the condensate collector, to the flue gas outlet
connection, to atmosphere.
Because of the low flue gas exit temperature there will be a vapor cloud formed at the flue gas terminal – this is
not smoke -, simply water vapor formed during the combustion process.
If the flue gas temperature falls below dew point 131°F [55°C], water vapor (created during the combustion
process) will begin to condense out in the boiler, transferring its latent heat into the system water, thereby
increasing the output of the boiler with-out increasing the gas consumption.
Condensation formed within the boiler and flue system is discharged from the boiler to an external drain via the
drain pan and siphon supplied.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich Gas 610 ECO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich Gas 610 ECO in the language / languages: English as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info