481717
63
Zoom out
Zoom in
Previous page
1/76
Next page
62
De Dietrich Gas 310/610 ECO
15.4 Maintenance
If during the annual inspection combustion results indicate that the boiler is no longer operating at the optimum
level additional maintenance should be carried out as follows:
The Gas310/610 ECO boiler or any of its components does not contain any crystalline silica.
Warning Electrical Shock Hazard:
Please label all wires prior to disconnecting when servicing this boiler. Wiring errors can cause improper operation
and dangerous operation. Verify boiler operation after service!!
Note:
Please ensure that the gas supply and main power supply is isolated before any maintenance work is carried out
on the boiler. Care should be taken when stripping the boiler for maintenance making sure that all parts, nuts,
washers and gaskets, etc. are kept safe, clean and dry for re-assembly. Following maintenance/cleaning, the
boiler should be re-assembled in the reverse order re-placing gaskets and joints where found necessary.
All general cleaning should be carried out with compressed air, a soft brush or damp cloth to avoid
damaging components. (Solvents must not be used).
Remove front and end casing panels lift casing panel slightly upwards and tilt toward you lift again clear of the
bottom rail.
15.4.1 Inspection of air box and dirt trap
The air box has a dirt trap on the inlet side. Check this for dirt, leaves, etc. If the boiler is closed, the clamping
strip under the casing must be removed first, check using a mirror if necessary.
Check the air box for dirt using a lamp. If the air box is dirty, it must be dismantled and blown clean. If the air box
is dirty, the following components must also be dismantled and blown clean:
non return valve
venturi
fan
Important!!
Ensure the balancing clips in the impeller stay in place!
Important!! The sealing between the burner and the mixing blend may be sticky. Prevent the sealing from
tearing. Damaged or hardened sealing must always be replaced.
15.4.2 Cleaning the non return valve
Use compressed air or a synthetic brush to clean the
non return valve.
15.4.3 Cleaning the Venturi
Use compressed air or a synthetic brush to clean
Venturi. Make sure that the hose between gas valve
and Venturi is clear and in good condition.
Fig. 29 non return valve being cleaned with soft brush
Fig. 30 Venturi being cleaned with compressed air
63


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich Gas 310 ECO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich Gas 310 ECO in the language / languages: English as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info