Selecting a programme
Switch the equipment on and select your
programme. The relevant light illuminates.
The selected programme remains in the memory
until the end of the cycle or following
cancellation during a programme.
Starting the programme
Close the dishwasher's door. Press the
"Start"
button . The display will show in minutes the
approximate time the programme has to left to
run.
To cancel a programme
Press the button for 3 seconds. The display
shows "00". You can then select a new
programme.
End of the programme
The indicator shows
“00”
until a new programme is
selected. Once the door is opened, the indicator
will again show the duration of the programme
previously selected.
Selecting the drying mode
With or without condenser
Your machine is factory set for drying with the
condenser active.
You can deactivate the condenser function (to
save water and energy): to do this, hold down
the " " button and depress the "Start "
button again.
If you want to reactivate the condenser function,
repeat the above operation.
Delayed start
After selecting your programme, press the
button under the display once for a delay of one
hour, twice for 2 hours, and so on for delays of
up to 24 hours.
Press the "Start " button to confirm your
selection.
The missing product indicator lights
goes on when the machine is turned on.
salt :
Lights up when salt is low. After you have
added regenerating salt it may stay on until the
salt has dissolved sufficiently. This happens
generally after a cycle (or if you have not
properly filled the machine – see page 27) for
example when starting off with the sample.
rinsing product :
Goes on, door ajar, when
you should add rinsing product (see filling page
28).
Economical and ecological washing
Do not pre-wash your dishes by hand.
Use all the capacities of your dishwasher. It will
wash economically and ecologically.
Always choose the programme best adapted to
the stains and the type of dishes.
Avoid using too much detergent, regenerating
salt and rinsing liquid. Observe the
recommendations contained in this manual
(pages 27 and 28) as well as the product
manufacturer’s instructions.
Make sure that the water softener is properly
adjusted. (see page 27)
GB
31
Operation
“
ON/OFF” button
: Press this button to switch the machine on.
Wash
button
: Press this button to select your programme.
Pause
Press this button to pause the programme.
Delayed start:
Pressing the button under the display screen delays the start of the
programme. Adjustable from 1 to 24 hours
Display screen
: This shows the approximate length of the programme, the delayed
start time and the water hardness setting.
Indicators lights:
For the remaining programme time in minutes and the remaining
time in hours before the start of the programme.
Indicators lights :
more regenerating salt rinsing product.
