Présentation de votre lave-vaisselle
32
What to do before using the machine for the first time
You must fill the salt reservoir with water when star-
ting to use the machine, even if the water softener set-
ting selected does not require any regenerating salt.
If you move house, you will have to reset the water softener.
STEP 1: Adjusting the water softener
For impeccable washing and drying results with no streaks.
➀➀
-
Measuring the water hardness
To do this: contact your local water supplier to find out the water
hardness level
OR measure the water hardness at the tap using the Aqua-test test-
ing strip supplied with your dishwasher and refer to the table below to
find out the setting to select according to the water hardness.
The water softener must be adjusted correctly to ensure no streaks
after washing and drying.
Your dishwasher is fitted with a water softening system that operates
using regenerating salt.
You must set the water softener according to the hardness of the water
in your area.
➁➁
-
Setting on the control panel
Drenching light permanently lit
Drenching light permanently lit
Intensive light permanently lit
Drenching light flashing
Salt
required
0 - 10°F
10 - 18°F
18 - 25°F
25 - 40°F
40 - 55°F
55 - 70°F
NO
YES
YES
YES
YES
YES
Water softener setting
Water
hardness
Testing strip
While holding down the ICS button, press the Start button: the
Drenching or Intensive programme light will illuminate and either
flash or be permanently lit to show the water softeners setting in
accordance with the above table.
To change the setting, hold down the ICS button and press the
Start button.
When the machine is first switched on, the setting is 10 - 25°F
(Drenching light permanently lit).
Intensive light flashing
Drenching light permanently lit
> 70°F
YES
Intensive light flashing
