50
IF YOU REALIZE THAT
WHAT SHOULD YOU DO?
➡ Lighting the burners:
There are no sparks when pressing the buttons.
✓ Check the electrical connections on the hob.
✓ Check that the sparkers are clean.
✓ Check that the burners are clean and in position.
➡ When lighting a burner, sparks appear at all of the
burners at the same time.
✓ This is normal. The lighter system is centralised, and
all the burners spark at the same time.
➡ Sparking takes place but the burners do not light
up.
✓ Check that the gas inlet pipe has not been squashed.
✓ Check that the gas inlet pipe tube is less than 2m
long.
✓ Check that the main gas tap is open.
✓ If you use gas tanks or cylinders check that they are
not empty.
✓ If you have just installed the hob or changed the gas
bottle, you should repeat the ignition procedure several
times until the gas reaches the burners.
✓ Make sure the injector is not blocked up. if this is the
case, clear it with a safety pin.
✓ Light up your gas burner before putting a pan on it.
➡ In the low position the flames go out or are too
high.
✓ Avoid any severe drafts in the room.
✓ Check that the gas you are using corresponds to the
injectors that have been installed (See injector identifi-
cation in the "Gas Rating" chapter).
Remember that gas hobs are delivered preset for use
with natural gas.
✓ Check that the gas change switch is correctly positio-
ned (please see the chapter on “Changing the type of
gas supply”).
✓ Call the After Sales Service dept for the adjustment of
the burner gas flow reduction.
Minor troubleshooting (cont’d)
➡ Flames are irregular.
✓ Check that the burners and injectors are clean and as-
sembled correctly.
✓ Check you have enough gas in your gas cylinders.
