26
Something not Working
Problems may be due to causes which
can easily be solved before calling the
Technical Service. Please follow these
instructions:
SYMPTOM
Door does not close
It is too warm inside the refrig-
erator
It is too cold inside the refriger-
ator.
The compressor works contin-
uously.
There is water inside/outside
the refrigerator.
Water comes out on the floor.
Noises
SOLUTION
Level properly the appliances if it is not well levelled.
Weight surpasses the storage limit of the door shelf so spread weight
more evenly or take some products out.
The appliance is not properly installed. Please look in the “Building-in”
section.
Set a lower temperature.
Distribute the food products to allow cold air to circulate around them.
Make sure that the door is completely closed and that the insulating strip
is complete and clean.
The temperature where the cabinet is placed is above normal room tem-
perature.
Turn the temperature regulator to a warmer setting temporarily.
Turn the thermostat knob to a lower number.
The temperature where the cabinet is placed is above normal room tem-
perature.
Check that the ventilation is sufficient and that the ventilation openings
are unobstructed.
The cause could be the introduction of large quantities of food and/or
frequent opening/closing of the door.
Sometimes is normal. During automatic defrosting frost thaws on the
cooling plate.
Place the drain hose at the back of the cabinet above the drain bowl.
Sometimes this is normal. Temperature control may cause clicking
sounds when the system is connected or disconnected.
The injected cooling gas may produce a gurgling sound while passing
through the tubes.
The motor may cause a humming noise and/or slight bumping.
The insulation material used has a tendency to slighly increase noise lev-
els, how ever it allows for much better insulation and a lower energy con-
sumption.
