34531

De Dietrich DHG 386 XP Manual

4
Zoom out
Zoom in
Previous page
1/12
Next page
4B5.
ENGLISH
DESCRIPTION
The appliance can be a filtering version one, a ducting version one.
In the Filtering version (Fig.1), the air and vapours conveyed by the appliance are depurated by charcoal filters and
recirculated around the room.
ATTENTION: When using the filtering version, two charcoal filters must be installed.
In the Ducting version (Fig.2), cooking vapours and odours are conveyed straight outside by a disposal duct which
passes through the wall/ceiling. Use of charcoal filters is therefore unnecessary.
INSTALLATION
The following operations are essential for assembly:
– Cut a hole in the bottom of the pensile cupboard in order to settle the appliance (Fig.3).
– Install the wiring system.
– Prepare the air venting hole if your appliance is to be installed in the ducting version.
– Insert the appliance in the hole (Fig. 3)
– Tighten the 2 screws inside the appliance (Fig. 4)
Ducting version
Using a proper pipe, connect the air venting flange of the apparatus to the air venting hole you made beforehand.
Make the electrical connection of the hood by means of the power supply cable.
Filtering version
To the air venting flange of the apparatus connect a proper pipe that can convey the air to the upper part of the pensile
cupboard. Make the electrical connection of the hood by means of the power supply cable.
OPERATION
Depending on the model, the unit is equipped with the following controls:
CONTROLS shown in Fig. 5:
A - Light ON/OFF switch
B - Motor ON/OFF - I speed switch
C - II speed switch - Pressing once more the timer starts working: it will turn the motor OFF after a 10’ working time:
the led blinks for all this time
D - III speed switch - The timer works as for switch C
E - IV speed switch - The timer works as for switch C.
At the end of a working time of about 30 hours, all the leds blink all together to tell that the grease filters must be cleaned.
After the cleaned filters are on again, press one of the three speed switches to allow the counting to start again.
When using the filtering version of the appliance, the charcoal filters must be changed according to use, usually
every six months.
- if the hood features a panel type charcoal filter (Fig.6), remove the two metal filter retainers (M) and position the charcoal
filter inside the grease filter; fit the two filter retainers back on again to secure the charcoal filter.
To take off the grease filter/s first press inward on the clamp at the handle and pull the filter downward (Fig.7).
Lighting: to change the halogen bulbs open the cover levering from the proper slots (Fig.8). Replace with bulbs
of the same type.
CAUTION: Do not handle glass bulb with bare hands. If, after replacing the halogen lights, these fail to work,
allow the appliance to cool and then interrupt power for a few seconds.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich DHG 386 XP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich DHG 386 XP in the language / languages: Dutch as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info