REPLACEMENT OR FITTING OF POWER SUPPLY CABLE
Follow the advice below: (see Fig. 38)
- Remove the rear panel of the cooker by unscrewing screws “B”
- Connect the power supply cable selecting the type indicated in
the table on page 18/19 “ELECTRICAL CONNECTION”
- Replace the rear panel using the same procedure in reverse.
COMMENTS
The earth conductor must be longer than the active conductors.
fig. 38
16
REPLACEMENT OF THE BURNERS AND SWITCHES
- To replace these accessories, remove the hob following the
sequence of instructions in Fig. 27 - 28 - 29
- To take the burners apart follow the sequence of instructions in
Fig. 36-37.
1) unscrew the lock nuts “C” and “D” and screws “E” (Fig. 36)
2) with the burner free turn and unscrew screws “F”.
fig. 36
fig. 37
